How do you reset the parameters on a Ford?
How do you reset the parameters on a Ford?
Cycle a key in ignition to RUN. Enter Security Access on the PATS control function module. Select “Parameter Reset” and then Exit Security Access. Perform a PCM Keep Alive Memory (KAM) reset.
How do I program a new Pat key?
Turn the ignition cylinder to OFF and then back ON (RUN) position. The dash will flash for fifteen more minutes. 4.After the security light stops flashing the third time, the new key has been programmed into the vehicles computer and will operate the car.
What are the Ford Pats fault codes DTC chart?
FORD PATS fault codes PATS DTC CHART DTC DESCRIPTION B1213 Less than 2 (or 3 if equipped w/Valet key) keys programmed to the system. B1232/B2103 Transceiver internal antenna damaged. Replace transceiver. B1342 ECU is defective (EEPROM in PCM is not working- replace PCM).
How to relearn Ford Pats control function module?
Enter “Ignition Key Code Erase.” Disconnect Tool and leave key in RUN for 20 seconds. Cycle key to OFF and then RUN. 2 keys required. Cycle key 1 to RUN. Enter Security Access on the PATS control function module. Select “Ignition Key Code Erase.” Disconnect Tool and leave key in RUN for 20 seconds. Cycle key 1 to OFF, then RUN, and back to OFF.
How to relearn Pats ignition key code program?
Cycle key 1 to RUN. Select “Ignition Key Code Erase.” Disconnect Tool and leave key in RUN for 20 seconds. Cycle key 1 to OFF, then RUN, and back to OFF. Cycle key 2 to RUN. Cycle an unprogrammed key in ignition to RUN. Enter Security Access on the PATS control function module. Select “Ignition Key Code Program.”
What do you need to know about Pats DTC?
The document includes a vehicle-to-PATS cross-reference chart, an ignition key identification photo-guide, a list of PATS DTC descriptions, and many PATS hints, tips, and relearns procedures.
How many coded keys do you need for Pats?
Coded: Requires challenge-response INCODE/OUTCODE authorization (you can obtain INCODEs using http://www.patscode.com/ or through Ford ETIS service) Minimum number of keys: Minimum number of programmed keys required for correct function of PATS (car won’t start if less then required number of keys is programmed). Number of coded keys:
Turn the ignition cylinder to OFF and then back ON (RUN) position. The dash will flash for fifteen more minutes. 4.After the security light stops flashing the third time, the new key has been programmed into the vehicles computer and will operate the car.
Enter “Ignition Key Code Erase.” Disconnect Tool and leave key in RUN for 20 seconds. Cycle key to OFF and then RUN. 2 keys required. Cycle key 1 to RUN. Enter Security Access on the PATS control function module. Select “Ignition Key Code Erase.” Disconnect Tool and leave key in RUN for 20 seconds. Cycle key 1 to OFF, then RUN, and back to OFF.
