How do you reset the electronic parking brake on a Honda Civic?

To do this:

Bring the vehicle to a stop with the brake pedal and shift to NEUTRAL.
Turn off the ignition, and push the parking-brake switch down within 2 seconds.
The automatic activation will be suspended, and will be restored when the vehicle is restarted.

How can I get my parking brake in service mode?

This can be done manually using the service port on the Electronic Parking Brake module and backing the motor off by hand, using the proper tool. A scan tool may also be used to get the Electronic Parking Brake assembly into service mode and is the preferred method.

How to change brake pads with an electric parking brake?

1. Connect a car battery charger 2. Connect a diagnostic tool 3. Replace brake pads and push back pistons 4. Press the foot brake pedal 5. Connect the diagnostic tool again 6. Set a basic Setting 7. Test the electric parking brake function You are done! How do I know if I need a computer to replace my rear brake pads?

Do you need to tension the parking brake?

But after the cables are replaced, the Electronic Parking Brake needs to be tensioned and this can only be done using a scan tool following the specific reset calibration procedure.

When to put the E-Brake in service mode?

Releasing the E-Brake and Putting the calipers into service mode are two different things. Most electronic E-Brakes require being put into a service mode in order to reset the caliper pistons, if you don’t, you run the risk of damaging the caliper/e-brake mechanism.

How to deactivate electronic parking brake service mode?

The brake caliper piston does not have to be rotated while compressing the piston. Carry out the following service mode deactivation procedure to activate the EPB system. Set the ignition to ON. Press and hold the accelerator pedal and place the EPB switch in the APPLY (upward) position. Continue to hold the accelerator pedal and the EPB switch.

When to replace rear brake pads in maintenance mode?

When replacing rear brake pads in maintenance mode, the brake caliper piston must be compressed into the caliper housing. The brake caliper piston does not have to be rotated while compressing the piston.

Do you have to deactivate EPB to replace rear brake pads?

4. To replace the rear brake pads, the EPB must be set in the Maintenance Mode before you retract the caliper pistons. You do NOT have to rotate the caliper piston like you did in previous model years. Ford calls this the deactivation procedure because you are deactivating the Maintenance Mode.

How do you reset the electronic parking brake on a Honda Civic?