How do you reset the check engine light on a 2014 Dodge Ram 1500?

How To Reset the Check Engine Light on a RAM 1500

Find your battery under the hood and disconnect the black/negative cable.
Wait 20 minutes for the power reserve to expire. The RAM 1500 check engine light should reset automatically during this time.
Now, just reconnect the black/negative cable.

When did the Check Engine light come on on 2014 Dodge Ram?

Three problems related to check engine light on have been reported for the 2014 Dodge Ram 1500. The most recently reported issues are listed below. Check engine light came on. That was 9/24/14. The check engine light has been through a myriad of “fixes”.

What to do if your Ram 1500 engine light goes out?

Ask your Ram dealer. No one has added a helpful site for this 2014 1500 problem yet. Be the first! Read reviews of repair shops in your area. Enter your zip code: Engine light came on in dash and would not go out. Had to take it to dealer who did something to it that I hope fixed the problem and not just made the light go out.

Where to find check engine light codes on Dodge?

These are listed in numerical order for easy searching. When retrieving Dodge check engine light codes with an OBD II scan tool, proceed as follows: 1. Connect scan tool to the 16-pin data link connector (DLC) located near the steering column. The connector may have a removable cover. 2. Turn the ignition on. 3.

What kind of engine does a 2014 Ram 1500 have?

2014 Ram 1500 Big Horn 3.6L V6 FlexFuel Crew Cab Pickup Checking the windshield washer fluid There’s no reason to check the washer fluid level without adding some – see how to do it here! 2014 Ram 1500 Big Horn 3.6L V6 FlexFuel Crew Cab Pickup

What does check engine light mean on 2014 Ram 1500?

A check engine light can indicate a broad spectrum of problems with your 2014 Ram 1500. In some cases you need to pull over immediately to prevent damage while in others you merely need to tighten you gas cap next time you stop in order to reset the service engine soon light.

How to reset the Check Engine light on a Dodge Ram?

Dodge Ram: How to Reset PCM and Check Engine Light. 1 Step 1 – Remove the PCM fuse. First, park your truck and turn it off. Pull the hood lever under the driver’s side dash, and then pull the safety catch 2 Step 2 – Reset the PCM. 3 Step 3 – Re-install the PCM fuse. 4 Related Discussions.

What’s the fuel empty light on a Dodge Ram?

It turns out to be a PO463 code. The CEL went off for a couple days but then today the chime sounded, fuel empty light came on and the gas gauge went to empty but the truck ran fine (this happened three times on the way to the shop). I wonder whether or not that falls under your 5 yr/ 100K powertrain warranty.

How do you reset the check engine light on a 2014 Dodge Ram 1500?