How do you reset the anti-theft system on a Dodge Caliber?
How do you reset the anti-theft system on a Dodge Caliber?
Insert the ignition key and turn it to the on position and then attempt to start the engine (crank over), the engine wont start. With the key still in the run position wait 10 minutes and the security light should blink and then go out. Turn the key off and wait 5 seconds.
Why does my Dodge Caliber have no start?
A no crank or no start condition may be the result of a theft system fault. Our technicians tell us that replacing the wireless control module should correct this issue. The average cost for a Dodge Caliber No Start Diagnosis is between $88 -$111.
Can a car anti theft system be disabled?
A car’s anti-theft system may activate if your key fob battery is dead and hasn’t disabled the system. Make sure the battery is installed correctly in your key fob. If the battery is correctly installed, replace it with a fresh battery and try again. Step 2: Check your door lock cylinder.
Where is the anti theft device on my car?
It’s located on your dash and will have a blue or red light. Step 2: Turn the ignition to the “on” position. Insert the key into the ignition and turn it to the on position, which activates your accessories but not the engine. Leave the key in position for about 10 – 15 minutes.
A no crank or no start condition may be the result of a theft system fault. Our technicians tell us that replacing the wireless control module should correct this issue. The average cost for a Dodge Caliber No Start Diagnosis is between $88 -$111.
A car’s anti-theft system may activate if your key fob battery is dead and hasn’t disabled the system. Make sure the battery is installed correctly in your key fob. If the battery is correctly installed, replace it with a fresh battery and try again. Step 2: Check your door lock cylinder.
It’s located on your dash and will have a blue or red light. Step 2: Turn the ignition to the “on” position. Insert the key into the ignition and turn it to the on position, which activates your accessories but not the engine. Leave the key in position for about 10 – 15 minutes.
