How do you replace the distributor on a Dodge Ram?
How do you replace the distributor on a Dodge Ram?
Unbolt the holding clamp and remove the distributor. Set the engine at Top Dead Center (TDC) mark of the No. 1 cylinder compression stroke with a socket with breaker bar (long-handled ratchet). Install the Ram distributor, replace the clamp and lightly tighten the bolt.
Where is the distributor on a V6 engine?
Look for the distributor – often, this is a cylindrical part with thick wires coming out of it that sits near the engine. Most distributors are located above ordinary V6 and V8 engines and to one side of inline I4 and I6 engines. The distributor has a plastic cap with spark plug wires coming out of it.
Can a engine start with a new distributor?
This step is crucial – if the position of the rotor in your new distributor doesn’t match the position of the rotor in your old distributor, your engine may not start with the new distributor installed. Carefully make a mark inside the distributor housing to indicate the position of the rotor.
How do you install a distributor on a car?
As you install the distributor, take care not to accidentally move or nudge the rotor. Mount the new distributor on the engine. Re-fasten the distributor in the same spot as the old distributor, lining up the marked location on the distributor housing with the engine mounting point.
Unbolt the holding clamp and remove the distributor. Set the engine at Top Dead Center (TDC) mark of the No. 1 cylinder compression stroke with a socket with breaker bar (long-handled ratchet). Install the Ram distributor, replace the clamp and lightly tighten the bolt.
This step is crucial – if the position of the rotor in your new distributor doesn’t match the position of the rotor in your old distributor, your engine may not start with the new distributor installed. Carefully make a mark inside the distributor housing to indicate the position of the rotor.
As you install the distributor, take care not to accidentally move or nudge the rotor. Mount the new distributor on the engine. Re-fasten the distributor in the same spot as the old distributor, lining up the marked location on the distributor housing with the engine mounting point.
How do you label the distributor wire on a Dodge Ram?
Using the diagrams located in Figure 4, label each spark plug wire with its associated cylinder number. Starting with spark plug wire #1, follow the engine firing order and label each successive spark plug wire by moving around the distributor in a clockwise motion. The remaining wire in the center of the distributor cap is the coil wire.
How do you replace a lower thermostat on a Dodge Stratus?
The metal housing the hose connects to is the lower thermostat outlet. Remove the hose from the outlet by loosening the band clamp and then by pulling the hose off the outlet. Be careful–some fluid will drain from the hose.
Where is the radiator hose on a Dodge Stratus?
Find the location where the upper radiator hose connects to the intake manifold of the engine by tracing it from the radiator to thermostat intake housing bolted to the intake. Remove the radiator hose from the thermostat intake housing by loosening the band clamp that secures it into place.
How do you replace the distributor on a car?
Transfer all of your marks to the new distributor and install it on the engine. The distributor rotor must align with the mark on the distributor housing (this is the mark that corresponds to the rotor contact inside the distributor cap).
