How do you replace power steering in a Chevy Silverado?

Reconnect the negative (black) battery terminal. Use a funnel to direct the power steering fluid into the pump, and pour until the fluid reaches the fill line. To make sure the power steering fluid is circulating throughout the entire system, turn on the engine and rotate the steering wheel left as well as right multiple times.

Why is my steering pin worn out on my GMC Sierra?

He told me that on the older Chevy and GMC trucks they have a “steering pin” (I’m assuming at the wheel) that tends to wear out and cause the symptoms my truck was having. Unfortunately I got a new phone since then and lost his number.

What kind of steering does a 98 GMC Sierra use?

List what you HAVE done and we can figure out what’s actually left. The 98 GMC Sierra doesn’t use rack and pinion steering. It uses a steering gear box. http://www.buyautoparts.com/autoparts/GMC/Sierra/Power_Steering_Gear_Box.html

How much does a GMC Sierra steering wheel cost?

These were replaced with ball-joints many years ago. The Sierra was just GMCs name for their pickups, The name was used on the 1500, 2500, and 3500 models. GM part number 12472161, priced at $102.60, referred to as a “king pin”.

What is power steering gear box for 1947 GMC Truck?

Our 1947-87 Chevy and GMC Truck Power Steering Conversion Gear Box really enhances the steering performance in your classic truck. Our power steering gear boxes are built to precise specifications and tolerances for added longevity. Works perfectly with our power steering kit numbers, PSK6066 and PSK4759.

Is it easy to replace a power steering pump?

Although power steering pumps are prone to wear and may eventually fail, they are not very complex components and moderately easy to replace. In trucks, however, heavier loads can put added pressure on the pump, and failure is usually quickened by the fluid as well as pump overheating.

Where is the oil catch on a power steering pump?

There are two hydraulic power steering lines connected to the pump: a supply line and soft return line. Place an oil catch pan directly underneath the power steering pump. Use an adjustable wrench to loosen the nut on the supply line, and remove the line to let the fluid drain into the pan.

How do you replace a power steering pulley?

The special puller consists of a split-ring flanged adapter, a ring, a puller bolt, and a puller nut with a flange. Slide the smooth end of the puller bolt into the hole in the pump shaft, and run the nut down to the pulley. Then place the two-piece adapter into the pulley groove and over the puller nut flange.

How much does a power steering pump replacement cost?

The average cost for a Chevrolet Tahoe power steering pump replacement is between $275 and $668. Labor costs are estimated between $174 and $221 while parts are priced between $101 and $447.

What to do if your power steering pump is not working?

If the serpentine belt does not hold the fan pulley from turning, try pressing on the belt while striking the wrench with a hammer. If it requires so much force that you turn the crankshaft, you will need to remove the serpentine belt (see steps 6-7) and hold the pulley with a strap wrench. Holding the fan blades won’t work.

How do you replace a power steering shaft?

Slip the ring over the two-piece adapter to keep it together. Use one wrench to hold the flanged nut, and another to turn the hex head of the puller bolt. As you tighten the bolt, the pulley will slide off the shaft. If you’re lucky.

When to know if your power steering pump is failing?

Signs that your power steering pump is failing are if the steering wheel is shaking heavily, the wheel is difficult to turn, and you hear a squealing or whining noise. If you notice these signs in your Silverado, follow the steps below to replace your power steering pump.

How do you replace the drive belt on a Chevy Silverado?

Attach a 15mm socket with ratchet and extension to the center bolt of the tensioner pulley. Rotate the bolt clockwise until enough tension on the drive belt is relieved. Then, remove the drive belt from all of the pulleys. Figure 6. Release the tensioner pulley.

What causes a locked steering wheel to not turn in?

If a locked steering wheel is the only thing preventing your key from turning the ignition, then follow our instructions below for How to Unlock a Locked Steering wheel and you will be back on the road fast. Problem 2. Dirt, pocket lint or debris (like tape from opening a package) may cause your key not to turn in your ignition lock cylinder.

How can I unlock a locked steering wheel?

1. Try pulling the key out a very small amount before gently turning key. (About 1/16 of an inch, the thickness of a nickel). 2. Wiggle key while trying to turn key gently.

Drain the power steering fluid until it comes out clean. Re-connect the lower pressure host to its fitting. Remove the jack stands and lower the truck. Pour new power steering fluid into the reservoir and turn the engine on. Let it cycle for a few seconds and check the power steering fluid level, adding more if necessary.

Where is the hydraulic fluid in a Chevy Silverado?

Power steering, like most of the mechanical systems in a Chevy Silverado, uses a special hydraulic fluid to operate. The liquid is called power steering fluid, and is found in a reservoir located in the engine bay. When this fluid gets old, it will create deposits throughout the power steering system.

Why is my Chevy Silverado power steering so loud?

When this fluid gets old, it will create deposits throughout the power steering system. The pump will have to exert extra pressure into the system to allow the deposit filled fluid to flow through it, which in turn causes the steering to be really loud. Over time, the dirty fluid can also damage the power steering pump.

What kind of problems does a Chevy Silverado have?

Noticed clunk in steering – dealer replaced intermediate steering shaft under warranty. Mechanic noticed leaking steering rack during normal service – GM agreed to replace under warranty even though it had expired. 295-horsepower 5.3L V8 4-speed automatic 4WD w/low range

Why is my steering not working on my Silverado?

Power Steering Fluid level is fine, hard to turn and it’s weak at low rpm/idle situations… but only when the steering was turned a bit. Seems to act up more when making a slow, low idle, left turn. Steering Position Sensor aka EVO the culprit or should i look else where? You can post now and register later.

Why does power steering turn one way but hard to turn the other way?

Power steering turns one way but hard to turn the other way. Gearbox or power steering pump problem? Can easily change both but need to be certain. I think its the gear box.

How can I Turn my steering wheel to the left?

Turn the wheel all the way to the left and hold it there tightly. Then loosen the hose line and and turn the wheel all the way to the right to bleed it out with hope that air comes out. Hold the wheel tight to the right while you tighten the hose back down. Have some fluid handy to refill the resivor.

Why is my power steering still hard to steer?

That sensor you mentioned is probably a power steering pressure switch. when you turn your wheels to lock and the strain on the pump puts a bigger drag on the engine it kicks the idle up a bit to compensate. Get your truck put on a service rack and have a mechanic get up close to the components to listen for noise while someone turns the wheel.

What to do if your steering wheel is hard to turn?

Get your truck put on a service rack and have a mechanic get up close to the components to listen for noise while someone turns the wheel. It will fix that.

How to change the power steering gear box?

Use a Motor FLush into the Power Steering PUMP.. Turn Engine on.. Let It FLOW and PUt one Quart of Cheap Power Steering Fluid. and Do it again.. Dump the Old Power Steering FLuid. Put a Prestone Power Steering Fluid. FInish..

What to do if your power steering looses?

This concern can be aggravated by worn tires, low tire air pressure, low power steering pump pressures, and tires larger than stock size. In some cases, where the power steering pump pressures are at the low end of the specification, replacing the power steering flow control valve with P/N 26095470 may improve the concern.

When did the GM power steering Evo come out?

The EVO itself is attached to the back of the power steering pump and was a new feature introduced by GM in 1997. A defective EVO wheel speed sensor will result in either excessive steering assist, or gaps in steering assist.

Can a power steering pump be replaced on a Chevy Silverado?

The power steering pump in your truck runs off the engine, and serves as a hydraulic assist for the steering rack. Although power steering pumps are prone to wear and may eventually fail, they are not very complex components and moderately easy to replace.

How to fix loose steering on Chevy Tahoe?

The only real PITA was getting at that locknut and adjuster. The trans cooler lines run right over top of the gearbox so it was not only hard getting the nut loose (constant flipping the open end wrench over and occasionally switching to the closed end box side), but getting the allen wrench in there was a PITA as well. Nice!

Is there a way to fix sloppy steering?

Surprisingly I didn’t find much info on this forum about correcting for sloppy steering so I figured I’d add a post for those of you wanting to try to correct this problem that plagues so many of us.

What to do if your steering wheel is loose?

To start, I’d suggest you have an alignment if you haven’t had one recently or your wheel isn’t at 12 o-clock position while driving. It will eliminate worn steering components as a source of the problem and possibly prevent you from ruining your gearbox if the designs used today have an ecentric lobe at center like the older designs did.

What kind of steering wheel do I need for a Silverado?

AmericanTrucks carries a wide selection of steering wheels available for you to purchase. These 99-06 Silverado steering wheels are designed to work perfectly with your truck and can replace your factory wheel, or even an aftermarket wheel that you already have.

Where is the steering column on a Chevy Silverado?

The steering column is located beneath the steering wheel, but it is not visible and is hidden behind the dash. Some of the most common symptoms of a failing steering column is a clicking or grinding noise when you turn, the steering tilt not locking into place, and the wheel operating very roughly.

Why does my Chevy Silverado steering wheel lock?

If you have ever tried to lock your steering wheel, you will notice that it locks in place and does not allow you to move it until the key is placed into the ignition. This is an anti-theft device that appears in most trucks and vehicles in general.

How do you replace power steering in a Chevy Silverado?