How do you replace a seal on a Chevy truck?
How do you replace a seal on a Chevy truck?
Drive the seal into the bore with a seal driver and hammer than slide the yoke back onto the pinion shaft, making sure the marks you made on the yoke and shaft align. Install the pinion nut and tighten it, seating the yoke on the shaft.
What happens if the pinion seal on a Chevy truck leaks?
If the pinion seal begins to leak, the fluid level can drop enough to damage those internal components and result in an expensive repair. Raise the rear of your Chevy off the ground with a jack and position a set of jack stands under the axle housing. Lower the jack and allow the truck to settle onto the jack stands.
How do you clean a front crankshaft seal?
Also clean the front of the crankshaft as well. Match the old seal to the new unit to make sure the inner and outer diameters are the same. Then apply a small amount of silicone sealer to the outer rim of the seal. This will help protect against any oil leaks from around the outside of the seal body.
How much does it cost to replace a front crankshaft seal on a car?
If you are having the job done at a repair shop except to pay between $250.00 and $550.00 depending on manufacturer and if the car is front wheel or rear wheel drive. A video of our mechanic performing this job is at the bottom of this guide. The car will need to be jacked up in most cases and supported on jack stands.
How to replace a front axle shaft seal?
If you have ever owned a GM four wheel drive vehicle then there is a good chance you have had a front axle shaft seal leak. We replaced the RH output shaft seal on a Tahoe but it is the same for Silverado, Sierra,Suburban and Yukon. Part one shows details on the tear down and part two with guide you through the reassembly. Loading…
What kind of axles do I need for a one ton Chevy?
The only thing stronger is the Rockwell axles but those are too much for our needs. Our current front axle is the ½-ton Corporate 10 Bolt axle with 28-spline shafts and a 8.5-inch ring gear. The Corp 10 axle is similar in size to the Dana 44 but the Dana 44 uses 30-spline shafts.
