How do you remove drive axle from Dakota?
How do you remove drive axle from Dakota?
Disconnect the brake calipers and mounting brackets from the discs by removing their bolts with a wrench, then slip the brake discs off. Disconnect the nut connecting the drive axle to the hub, placing a pry bar between two of the wheel studs to keep the hub from turning.
Where are the front axles on a Dodge Dakota?
Front axle assemblies are only used on four-wheel drive models of the Dodge Dakota truck. The axle assembly is connected to the engine and the differential. You may need to disconnect other components depending on the exact year of the Dakota.
How do you remove axles from a Dodge Durango?
Raise a floor jack under the differential to support the axle assembly. Remove the assembly’s bolts and fasteners at the left engine mount, pinion nose bracket and right engine mount and then lower the jack to remove the axles. “Dodge Durango & Dakota: 2004-2006 (Chilton’s Total Car Care Repair Manual)”; John Wegmann; 2008
Front axle assemblies are only used on four-wheel drive models of the Dodge Dakota truck. The axle assembly is connected to the engine and the differential. You may need to disconnect other components depending on the exact year of the Dakota.
Disconnect the brake calipers and mounting brackets from the discs by removing their bolts with a wrench, then slip the brake discs off. Disconnect the nut connecting the drive axle to the hub, placing a pry bar between two of the wheel studs to keep the hub from turning.
Raise a floor jack under the differential to support the axle assembly. Remove the assembly’s bolts and fasteners at the left engine mount, pinion nose bracket and right engine mount and then lower the jack to remove the axles. “Dodge Durango & Dakota: 2004-2006 (Chilton’s Total Car Care Repair Manual)”; John Wegmann; 2008
What kind of bolts do you need to remove a driveshaft?
Remove Driveshaft Bolts Remove the shaft differential flange mounting bolts. These bolts will be very tight so use good quality tools to avoid stripping. Some bolts can head 12 point heads as in this example which used a 13mm 12 point socket to remove.
