How do you remove camshaft gear from a car?

1. Verify that the timing mark on camshaft gear (1) is aligned with Timing Mark (X) on front housing (3) . 2. 3. Remove top bolt (2) from camshaft gear (1) . Install Tooling (A) in place of the bolt. 4. Remove remaining bolts (2) and remove camshaft gear (1) . NOTICE Do not turn the crankshaft or the camshaft while the camshaft gear is removed.

How to remove the gear from a crankshaft?

Block the flywheel from moving by placing a 22 X 19 mm wrench in the lighting hole of the flywheel and over the boss for the engine mounting stud. Use the 12 mm socket and ratchet to tighten up the bolt… …then use the block of wood and hammer to beat the gear on a bit more.

How to remove the timing gear from a car?

Insert a large screw driver between the teeth of the flywheel and case… …to keep the flywheel/crank from turning when pulling the crank gear. Use the 12mm socket, extension and ratchet to remove the gear retaining bolt. Crank bolt, tab washer and washer plate. Note the plate has a cut-out for the key which holds the gear.

Where is the timing mark on the camshaft gear?

The timing mark on the camshaft gear must be aligned with the timing mark on the front cover when the No. 1 piston is at the top center of the compression stroke.

How do you remove a valve from a camshaft?

Use the blade of a flathead screwdriver to pry each valve lifter out of the engine. Remove the harmonic balancer and the timing chain cover. Remove the large bolt located in the center of the harmonic balancer with a wrench, then attach a harmonic balancer puller to the balancer.

How do you replace cam bolts on a car?

Be prepared to replace the cam bolts with something more durable. The specs are: M10x1.50 (Metric 10 by 1.50 pitch) 1.25″ long 1. Remove the intake pipe. 2. Detach the accelerator cable and the speed control cable (if equipped). 3. Remove valve cover and the timing belt.

How do you remove camshaft gear from a car?