How do you remove bearings from a wheel?
How do you remove bearings from a wheel?
Remove the outer bearing cone assembly. Pull the rotor/hub assembly off the spindle – the inner bearing cone assembly, inner cup, outer cup and seal will come with it. Use a seal puller to remove the seal, then remove the inner bearing cone assembly from the rotor/hub.
How do you replace a wheel bearing cone?
Use a seal puller to remove the seal, then remove the inner bearing cone assembly from the rotor/hub. Discard the seal after removal. Use a cup driver or mild steel bar to remove the inner cup and the outer cup from the hub assembly. 2. Clean and Inspect Hubs and Spindles. Remove all old lubricant from the rotor/ hub assembly and spindle.
Where can I get a new wheel bearing?
If your bearing is pressed into the spindle, it is recommended that you remove the spindle from the vehicle and take both the spindle and the new wheel bearing to your local repair shop. They will have the specialty tools to press out the old bearing and press in the new one. In most cases this service can be done inexpensively.
How to clean and repack wheel bearings and lug nuts?
Step 3: Remove the wheel from the hub. After the vehicle is raised, start on one side and complete the side before moving onto the other. The first step here is to remove the wheel from the hub. Use an impact wrench and socket or a star wrench to remove the lug nuts from the wheel.
How much does it cost to replace a wheel bearing?
How Much Does Wheel Bearing Replacement Cost ? March 24, 2020 / 0 Comments / in Car Repair , Wheel Bearing / by Bridwell On average, wheel bearing replacement costs about $441 in the US for 2020, wheel bearing replacement costs can range from $383 to $498 according to RepairPal.com , and other sources.
When does a wheel bearing need to be replaced?
Most wheel bearings are sealed at the factory and don’t typically require replacement until around 150,000 miles or 240,000 kilometers, but there are some cars on the road whose wheel bearings do require regular service.
What tools are needed to change a wheel bearing?
Tools needed to change rear wheel bearings: A socket to fit the lug-nuts (Could be lots of different sizes but mine are a 17mm) so you can remove the wheels. 1. A 32mm socket and impact wrench (fits the axle nut). 2. A 17mm+14mm socket and ratchet or wrench(fits the two bolts holding the spindle in place).
How do you change wheel bearings?
To change wheel bearings, start by lifting the wheel up on a jack, unscrewing the lug nuts, and taking the wheel off. Then, remove the brake caliper, the dust cover over the rotor, and the cotter pin and castle nut behind the dust cover.
