How do you remove a window regulator from a motor?
How do you remove a window regulator from a motor?
Start by removing the window-to-regulator bolts (have someone hold the glass while you do this). Then remove the glass by tilting it away from the door and lifting it out. Next, remove the regulator bolts or rivets (drill them out and snake the old regulator out through one of the door panel openings.
How do you remove a power window motor?
Remove the motor and regulator through the access port. With the pigtail disconnected, the power window motor and regulator will no longer be connected to anything inside the door. Reach into the large access port and pull them each out. The two are connected, so pulling one will remove them both.
Where is the regulator on a power window?
Locate and remove the window motor mounting bolts. The power window motor is much smaller than the regulator, but should be located close by. In most applications, the bolts securing the motor to the door are the same size as the regulator mounting bolts. Remove them and set them someplace safe as well.
How do you remove a window regulator from a door?
Reach down into the door through one of the access holes and remove the power connections from the motor. Make a note of which connection goes where. Now remove the bolts that hold the window regulator inside of the door.
What should the current be on a power window motor?
With analog motors, checking between the two wires should show either 12 volts or -12 volts, depending on the position of the switch. Full current available and a motor that does not run suggests a bad motor. A lack of current flow means power is not reaching the motor and the problem is upstream.
Remove the motor and regulator through the access port. With the pigtail disconnected, the power window motor and regulator will no longer be connected to anything inside the door. Reach into the large access port and pull them each out. The two are connected, so pulling one will remove them both.
Reach down into the door through one of the access holes and remove the power connections from the motor. Make a note of which connection goes where. Now remove the bolts that hold the window regulator inside of the door.
Locate and remove the window motor mounting bolts. The power window motor is much smaller than the regulator, but should be located close by. In most applications, the bolts securing the motor to the door are the same size as the regulator mounting bolts. Remove them and set them someplace safe as well.
How to remove and replace 99-06 Silverado window motor, no regulator?
How To: Remove & Replace 99-06 Silverado Window Motor, No Regulator! If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.
