How do you remove a fuel pump from a Toyota Tundra?
How do you remove a fuel pump from a Toyota Tundra?
Fuel tank connector. Now that the tank is removed from the truck, you can remove the fuel pump assembly. First, remove the two fuel lines on top of the fuel pump assembly; this is done by prying the clips off and pulling the lines out. Next, you need to unscrew the retaining cap on the fuel pump assembly.
Where is the fuel line on a Toyota Tundra?
Emissions line. At the top of the tank, remove the wiring harness as shown in Figure 5, then remove the two fuel line connectors at the front of the tank as seen in Figure 6. The fuel lines will drip some residual fuel once the connectors are removed, so have your bucket ready!
What kind of system does a Toyota Tundra have?
SRS airbag system, multiport fuel injection system/sequential multiport fuel injection system, discharge warning light, ignition system, vehicle stability control system, front passenger occupant classification system How to check the fuses? How to replace a blown fuse?
Where are the fuse panels on a Toyota Tundra?
Here you will find fuse box diagrams of Toyota Tundra 2000, 2001, 2002, 2003, 2004, 2005 and 2006, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.
How many miles does a 2000 Toyota Tundra have?
Hello all! I have a 2000 4.7 liter tundra with 208,xxx miles. I bought it a few months back and haven’t had any problems with it until now. 2 weeks ago I was driving down the highway when Noticed misfiring, loss of power and a flashing check engine light. Took it home and ran the codes, p0305 and p0155.
What kind of engine does a Toyota Tundra have?
The injection system used eight four-hole type fuel injectors (one for each cylinder), the mass air flow meter, and two air-fuel ratio sensors. The engine is equipped with Toyota’s Direct Ignition System (DIS) which uses individual ignition coils for all eight cylinders and iridium spark plugs.
How does the 0 work on a Toyota Tundra?
The 0 is true TDC, the dowel is 15 degrees after TDC. By turning it 15 degrees ATDC tension is reduced on the vavle springs and you will less likely have the cam gear turn on you once the t-belt is off. Using the 0 works, instead of matching to the T you would match to the I, but a cam gear might turn on you if you happen to bump the vehicle.
What to do about a misfire in a Toyota Tundra?
If you have any doubt as to were top dead center is (TDC) pull spark plug #1 and insert a long enough rod down inside and put a dial indicator on top of the rod and measure. You can almost get it perfect with the naked eye. Now looking at your belt, which is 100 times better than mine when I replaced my timing belt.
