How do you remove a fan speed resistor?
How do you remove a fan speed resistor?
How to Replace a Blower Motor Resistor
- Remove the negative battery terminal.
- Locate the blower motor resistor on the passenger side under the dash board.
- Disconnect the electrical connector to the blower motor resistor.
- Remove the screws or bolts to the blower motor resistor and remove the resistor.
How do you replace a cooling fan resistor?
Visually inspect the replacement cooling fan resistor, comparing it to the one that was removed. Verify that it is the same general dimension and the same number of wires, that the wires are color-coded the same, that the connecter is the same type, and so on. Step 5: Install the replacement cooling fan resistor.
How do you replace a fan resistor on a Mini Cooper?
Use a 10mm socket and remove the two bolts holding the resistor and cover to the shroud (red arrows). Slide the resistor out from the shroud and pop open the cover protecting the wiring (red arrow). The new resistor is a direct replacement for the old one you just need to cut the original wires from the harness and splice in the new ones.
How to replace a resistor on a pelican cooling fan?
Replacing the resistor with a new one (yellow arrow) is simple even if you are working on wiring for the first time. Use a 10mm socket and remove the two bolts holding the resistor and cover to the shroud (red arrows). Slide the resistor out from the shroud and pop open the cover protecting the wiring (red arrow).
How to replace a blower resistor in a car?
1. De-energize air bag. 2. Remove the dashboard, the manual calls it the ‘instrument panel’. Follow the manual except for the following: a. Do not remove the steering wheel or air bag. b. Do not remove the shifter lever or boot. The boot can more rolled out of the way.
Visually inspect the replacement cooling fan resistor, comparing it to the one that was removed. Verify that it is the same general dimension and the same number of wires, that the wires are color-coded the same, that the connecter is the same type, and so on. Step 5: Install the replacement cooling fan resistor.
Use a 10mm socket and remove the two bolts holding the resistor and cover to the shroud (red arrows). Slide the resistor out from the shroud and pop open the cover protecting the wiring (red arrow). The new resistor is a direct replacement for the old one you just need to cut the original wires from the harness and splice in the new ones.
Replacing the resistor with a new one (yellow arrow) is simple even if you are working on wiring for the first time. Use a 10mm socket and remove the two bolts holding the resistor and cover to the shroud (red arrows). Slide the resistor out from the shroud and pop open the cover protecting the wiring (red arrow).
1. De-energize air bag. 2. Remove the dashboard, the manual calls it the ‘instrument panel’. Follow the manual except for the following: a. Do not remove the steering wheel or air bag. b. Do not remove the shifter lever or boot. The boot can more rolled out of the way.
