How do you remove a belt from a caterpillar water pump?
How do you remove a belt from a caterpillar water pump?
Insert a ½-inch breaker bar in the tension adjuster on the alternator to reduce the tension on the belt. Push the breaker bar to the left and remove the belt from the alternator pulley when the tension releases. Loosen, but do not remove, the tension adjuster above the water pump.
How do you remove a serpentine water pump belt?
If it is a serpentine belt, remove the belt by using a breaker bar and turning the tensioner to relax the belt. If the vehicle has a v-belt, loosen the tensioner to relax the belt. Step 6: Remove the belt or belts from the pulleys. Step 7: Locate the tensioner to the belt.
What to do if your water pump belt breaks?
Step 1: Open the hood to the engine compartment. Grab a flashlight and visually check the water pump belt for any weather cracking or breaks. Step 2: Push on the belt to make sure that the tensioner is working correctly. For serpentine belts, the tensioner should move as the belt is being pushed on.
How do you install a V belt on a water pump?
If you have to install a v-belt, slide the tensioner over and tighten it. Make adjustments to the v-belt by loosening and tightening the tensioner until the belt is loose to its width or about a 1/4 inch. Step 11: Install the belt onto the pulleys.
Insert a ½-inch breaker bar in the tension adjuster on the alternator to reduce the tension on the belt. Push the breaker bar to the left and remove the belt from the alternator pulley when the tension releases. Loosen, but do not remove, the tension adjuster above the water pump.
How to change a cat water pump on C7, 3126?
How To Change a Cat Water Pump On C7, 3126, and C9 Engines. – YouTube How To Change a Cat Water Pump On C7, 3126, and C9 Engines.
Can you replace the serpentine belt on a cat 330?
Asked about replacing the Serpentine belt on our rear radiator Cat 330. Almost immediately started about removing the radiator, but I was assured that that they routinely replaced them.
What to do if your cat 330 overheats?
Insure that the water pump belt is in good condition and properly tensioned (it is NOT on an automatic tensioner). Verify that thermostat (s) are not over 3 years (per Caterpillar recommendation). BTW, Caterpillar calls thermostats “regulators”.
