How do you put a Sentry Key in a ignition?
How do you put a Sentry Key in a ignition?
Insert one of the two valid Sentry Keys into the ignition switch and turn the ignition switch to the On position. 3. After the ignition switch has been in the On position for longer than three seconds, but no more than fifteen seconds, cycle the ignition switch back to the Off position.
How to change Sentry Key theft deterrent system?
When a Powertrain Control Module (PCM) is replaced on vehicles equipped with the Sentry Key Theft Deterrent System (SKIM), it must be initialized to properly function with the anti-theft module. This is accomplished at a Chrysler Group Dealer by using the DRBIII or StarSCAN Scan Tool to enter a PIN number.
When did the Sentry Key immobilizer system come out?
Sentry Key Immobilizer System Beginning in 1998, selected Chrysler products began rolling off the assembly lines with a new advanced security system known as the Sentry Key Immobilizer System (SKIS). Many newer Cherokees are equipped with this feature.
How to repair Sentry Key in Chrysler skim?
Connect the CH9043 MUX Cable, and the DRBIII (with the CH9044 Crossfire Software card or CH 9087 Sprinter Software card plugged into it); to the vehicle. Using the DRBIII select: c.Make the appropriate selection: “2004-2005 Crossfire” or “2003-2004 Sprinter” f.Record the ten (10) character “P/N” on the repair order for later reference.
Sentry Key Immobilizer System Beginning in 1998, selected Chrysler products began rolling off the assembly lines with a new advanced security system known as the Sentry Key Immobilizer System (SKIS). Many newer Cherokees are equipped with this feature.
When a Powertrain Control Module (PCM) is replaced on vehicles equipped with the Sentry Key Theft Deterrent System (SKIM), it must be initialized to properly function with the anti-theft module. This is accomplished at a Chrysler Group Dealer by using the DRBIII or StarSCAN Scan Tool to enter a PIN number.
How do you replace a Sentry Key in a Chrysler?
1.Before replacing the PCM, with the ignition switch in the “RUN” position, determine the part number of the PCM software. Connect the CH9043 MUX Cable, and the DRBIII (with the CH9044 Crossfire Software card or CH 9087 Sprinter Software card plugged into it); to the vehicle.
Is there a Sentry Safe 3e2 replacement key?
Sentry Safe Keys 3E2 Replacement Keys Cut Keys Will Work Out of The Envelope Check Your Lock 3E2 Should Be Stamped on Your Lock. Works Sentry Safe 1100 1160 1170 1200 HO100 1170BLK H0100 & More . Only 11 left in stock – order soon.
