How do you install a new windshield wiper shaft?
How do you install a new windshield wiper shaft?
Install the new arm. Line up the splines so that they mate with the shaft. Make sure that your wiper arm is in the correct resting position on the windshield (it should land on the same mark you made with the original wiper). Gently tap the arm down onto the shaft. It is ideal to use a tool that will not scratch your new wiper arm.
How do you tighten a hex nut on a windshield wiper?
Tighten the hex nut by turning your ratchet clockwise until it gets snug, then go about 1/8 of an inch more to secure the nut. To learn how to replace the windshield wiper arm if tightening the retaining nut doesn’t work, read on!
What should I do if my windshield wiper arm slips?
Test the wipers. Turn the ignition key on, turn the wipers on and test the travel of the arm for proper operation. If the arm slips, you will need to replace it. Mark where the windshield wiper blade rests. If your wiper problem was not the result a loose nut, your wiper arm might be stripped out. In this case you need to replace it.
What happens if a retaining nut comes loose on a windshield wiper?
However, doing this can cause a wiper retaining nut to come loose and make the wipers unusable. Turn the windshield wiper switch off. You should allow the blades to drop into the rest position.
Tighten the hex nut by turning your ratchet clockwise until it gets snug, then go about 1/8 of an inch more to secure the nut. To learn how to replace the windshield wiper arm if tightening the retaining nut doesn’t work, read on!
Why does my windshield wiper not move after turning on the switch?
When the wiper blades don’t move after turning on the switch, it’s often caused by a malfunction in the wiper motor. Although the likelihood of having a problem with your windshield wiper motor is rare, there are a few warning signs that will alert you that the wiper motor is damaged or needs to be replaced.
Install the new arm. Line up the splines so that they mate with the shaft. Make sure that your wiper arm is in the correct resting position on the windshield (it should land on the same mark you made with the original wiper). Gently tap the arm down onto the shaft. It is ideal to use a tool that will not scratch your new wiper arm.
Test the wipers. Turn the ignition key on, turn the wipers on and test the travel of the arm for proper operation. If the arm slips, you will need to replace it. Mark where the windshield wiper blade rests. If your wiper problem was not the result a loose nut, your wiper arm might be stripped out. In this case you need to replace it.
