How do you fix the airbag light on a PT Cruiser?

How do you fix the airbag light on a PT Cruiser?

How to Reset the Airbag in a PT Cruiser

1. Locate the OBD port that is the same shape as the OBD scan tool’s connector end.
2. Plug the scan tool into this port.
3. Wait for the scan tool to interface with the computer.
4. Unplug the scan tool and start the engine.

Can the airbag light be turned off?

An airbag warning light can not turn itself off and has to be manually reset. When an airbag light comes on, there is something wrong with the airbag system. It could be a malfunctioning airbag, a faulty sensor, or just a slight technical issue.

Where are airbag impact sensors located?

The location of airbag sensors differs from car to car. The most common location is inside the front bumper or fender, however many modern vehicles have several airbag sensors. They can also be found inside the engine bay, in the passenger seat area, or even in the rear or sides of the vehicle.

Will removing fuse disable airbag?

Every vehicle I’ve worked on has had an airbag fuse you can remove from the fuse panel to fully disable the airbag; the repair manuals recommend pulling this fuse when doing any work in the dash area since there’s some risk of triggering the airbags to go off while you’re working, which could result in serious injury …

How do you disable airbag sensor?

How to Turn Off the Airbag Light

1. Turn on the ignition switch with your car key.
2. Wait for the airbag warning light to turn off.
3. Turn the ignition switch of your car back off for a little longer than three seconds.
4. Repeat steps 1 through 3 twice to make three times total.

How do I reset my airbag light?

How to Reset an Airbag Light

1. Put the key into the ignition and turn the switch to the “on” position.
2. Watch for the airbag light to turn on. It will stay illuminated for seven seconds and then shut itself off. After it shuts off, immediately turn the switch off and wait three seconds.
3. Repeat Steps 1 and 2 two more times.

Can you unplug an airbag sensor?

There is no way you can unplug anything to disable the airbag system. It is integrated into too many necessary circuits. If the light is on, the trouble code is already set, and will stay set until you have it reset.

Where is my airbag module located?

In most cars it is under the center console that is between the two front seats, or center of the dash on the floor. In most GM cars it is under the driver or passenger seat. Disconnect the positive battery cable and wait 3 min. You are now safe to unplug the airbag control module harness wiring plugs.