How do you clear diagnostic codes on a Ford Escape?

To clear the codes, back out of the “read codes function” and select “Clear Code”s. A prompt will ask you if you are sure you want to do this, and if you are, then select “yes”. This is the only way to totally clear codes. Disconnecting the battery will remove them from the current list, but leave them stored as a memory code.

Where is the diagnostic port on a Ford Escape?

by Lee Sallings. The Ford Escape uses an OBD II diagnostic port located under the left side of the dash near the steering column. Pulling trouble codes requires the use of an OBD II capable code reader or scan tool, with the scan tool being preferable because it gives more diagnostic information than a code reader does.

What’s the trouble code for a Ford engine?

Trouble Code. Fault Location. Probable Cause. P0171. Fuel trim (FT) system too lean, bank 1. Intake/exhaust leak, AIR system, MAFNAF sensor, fuel pressure/pump, injector (s), HO2S. P0300. Random Cylinder Misfire (Cylinder Not Specified) Spark plug (s), HT lead (s), injector (s), ignition coil (s), low compression, wiring.

What’s the trouble code for a Ford Fusion?

Any suggestions?… Truck stalled out, wouldn’t start again, got p0191 code, I’ve changed FRP sensor, changed fuel pump driver module, fuel pump, and fuel filter…now it finally starts again, but won’t stay running and when I give it gas it bogs out any suggestions ?… 2014 ford fusion 2.0l p0087 code is displayed on the scanner.

What are the trouble codes Ford Explorer?

The P0304 trouble code will trigger the Explorer’s service engine soon light.
The vehicle itself may begin to run rough. It depends on how serious the misfire is.
especially at lower RPM.
Fuel mileage may suffer.
You may smell raw gas coming from the tail pipe.
The vehicle may backfire.

What are Ford OBD trouble codes?

Refer to our Generic OBD II code list for definitions on all other Ford diagnostic trouble codes. P1000 OBD System Readiness Test Not Complete P1001 KOER Test Cannot Be Completed P1039 Vehicle Speed Signal Missing or Improper P1051 Brake Switch Signal Missing or Improper P1100 Mass Air Flow Sensor Intermittent

What is a Ford trouble code?

What Is a Ford Trouble Code P1151? This trouble code is signaled by your heated exhaust oxygen sensor, or HO2S. This sensor is used to test the amount of oxygen to ensure an accurate air/fuel ratio. A failed test means there isn’t enough air mixing with your fuel. This could be the result of improper air intake.

How do you clear diagnostic codes on a Ford Escape?