How do I reset my Brother HL 5470DW printer?

How do I reset my Brother HL 5470DW printer?

Step 1: Turn on the Brother HL-5470DW. Step 2: Open the front cover of the printer by pressing the front cover release, then pulling the front cover forward. Step 3: Press and hold the green Go button for five seconds, until you see a message on the display that says Drum Clear.

How do I reset the drum on my Brother laser printer?

Reset the Drum Counter

1. Close the front cover.
2. Make sure the machine is turned on.
3. Press. (Settings).
4. Press All Settings. (This step might be skipped in some models.)
5. Choose Machine Info. or Machine Information => Parts Life.
6. Press and hold Drum or Drum Life until the machine’s display message changes.
7. Press Yes.
8. Press.

How do you reset the drum on a Brother HL 5440D?

Brother HL-5440D – Reset Drum This will turn off the drum warning light on the printer. Simply open the front cover, and hold the “GO” button until all four LED’s are lit. Release the “GO” button and close the front cover.

Why is my Brother printer printing blank pages when it has ink?

If there is insufficient ink in your cartridge, your Brother printer may print blank pages. If you are using a wireless Brother printer, an improper internet connection can cause this issue. If the ink cartridge is not installed properly or is of low quality, it will print blank pages.

How do I make my Brother printer discoverable?

Configure the wireless settings:

1. Place the Brother machine within range of your WPS or AOSS™ access point/router.
2. Make sure that the power cord is plugged in.
3. Turn on the machine and wait until the machine is in the Ready state.
4. Hold down the WPS or AOSS™ button on your WLAN access point/router for a few seconds.

Where is the IP address on a Brother printer?

Press the [Menu] and navigate to the WLAN tab (using the ▲/▼ arrows and the [OK] button) Press ▲ and select WLAN Status. Select Infrastructure Mode. The screen will display your network connection settings, your IP Address is listed on the third line.

How do I clean the drum on my Brother printer?

Clean the roller by gently wiping the entire surface of the drum with an alcohol swab, such as a medical pad or wipe, or cotton swab lightly moistened with isopropyl alcohol (91% strength alcohol is preferred, but 70 75% strength alcohol is also acceptable).