How do I reprogram a Pats key?
How do I reprogram a Pats key?
Within ten seconds, remove the first original key and insert the second original key, and then turn to ON (RUN) for three seconds, and then back to OFF. 6. Within ten more seconds, insert the new key and turn to ON for three seconds, then turn back to OFF.
How to program new Pats key for Ford manually?
3.Remove the existing key and, within TEN seconds, insert a second working key and turn it to ON (RUN) and the back OFF. Ignition must be in ON for at least ONE second, but no more than TEN seconds.
How to relearn Pats ignition key code program?
Cycle key 1 to RUN. Select “Ignition Key Code Erase.” Disconnect Tool and leave key in RUN for 20 seconds. Cycle key 1 to OFF, then RUN, and back to OFF. Cycle key 2 to RUN. Cycle an unprogrammed key in ignition to RUN. Enter Security Access on the PATS control function module. Select “Ignition Key Code Program.”
How to reset the Pats parameter on a Ford?
Enter Security Access on the PATS control function module. Select “ICM / PCM Parameter Reset.” Select “PCM / TCM Parameter Reset” and then Exit Security Access. (for type F) Disconnect the diagnostic tool for 20 seconds before cycling ignition to OFF, ACC, or RUN.
How to relearn Ford Pats code erase procedure?
Select “Ignition Key Code Erase.” Disconnect Tool and leave key in RUN for 20 seconds. Cycle key 1 to OFF, then RUN, and back to OFF. Cycle key 2 to RUN. 2 keys required. Cycle key 1 to RUN. Select “Ignition Key Code Erase.” Disconnect Tool and leave key in RUN for 20 seconds. Cycle key 1 to OFF, then RUN, and back to OFF.
3.Remove the existing key and, within TEN seconds, insert a second working key and turn it to ON (RUN) and the back OFF. Ignition must be in ON for at least ONE second, but no more than TEN seconds.
Cycle key 1 to RUN. Select “Ignition Key Code Erase.” Disconnect Tool and leave key in RUN for 20 seconds. Cycle key 1 to OFF, then RUN, and back to OFF. Cycle key 2 to RUN. Cycle an unprogrammed key in ignition to RUN. Enter Security Access on the PATS control function module. Select “Ignition Key Code Program.”
Enter Security Access on the PATS control function module. Select “ICM / PCM Parameter Reset.” Select “PCM / TCM Parameter Reset” and then Exit Security Access. (for type F) Disconnect the diagnostic tool for 20 seconds before cycling ignition to OFF, ACC, or RUN.
Select “Ignition Key Code Erase.” Disconnect Tool and leave key in RUN for 20 seconds. Cycle key 1 to OFF, then RUN, and back to OFF. Cycle key 2 to RUN. 2 keys required. Cycle key 1 to RUN. Select “Ignition Key Code Erase.” Disconnect Tool and leave key in RUN for 20 seconds. Cycle key 1 to OFF, then RUN, and back to OFF.
