How do I replace the speakers in my car?
How do I replace the speakers in my car?
Install the door panel sliding it down and make sure it engages in the channel at the top of the door near the glass. Push the door panel in and install all the screws you removed earlier. If you need to replace one of the speakers consider replacing both speakers on each side of the car.
How do you remove a speaker from a door?
Pry off the screw cover behind the door handle and then remove the exposed screw. Pull off the trim surrounding the door handle. Pry out the bottom of the door panel and remove the panel from the door. Remove the four Phillips screws holding the speaker in place. Pull the speaker out and unplug the wiring connector.
How do you put a speaker in a front door?
Pull off the trim surrounding the door handle. Pry out the bottom of the door panel and remove the panel from the door. Remove the four Phillips screws holding the speaker in place. Pull the speaker out and unplug the wiring connector. Plug your new speaker in and place it into the opening in the door.
What to do if front passenger door speaker is bad?
For example if the speaker in the front passenger door is bad, set the majority of the sound to the rear speakers and shift the balance a little bit the the left. This is not a perfect solution but a temporary one until you get the time to replace the bad speaker. NOTE: DISCONNECT THE GROUND WIRE FROM THE BATTERY FIRST.
Pry off the screw cover behind the door handle and then remove the exposed screw. Pull off the trim surrounding the door handle. Pry out the bottom of the door panel and remove the panel from the door. Remove the four Phillips screws holding the speaker in place. Pull the speaker out and unplug the wiring connector.
When did I replace my front door speakers?
Sound great but not recommended! I replaced the front door speakers in my 2001 Silverado in December of 2012 with these same AC Delco speakers at $38 each. Recently, the voice coil of one of the new speakers went open.
Pull off the trim surrounding the door handle. Pry out the bottom of the door panel and remove the panel from the door. Remove the four Phillips screws holding the speaker in place. Pull the speaker out and unplug the wiring connector. Plug your new speaker in and place it into the opening in the door.
What kind of speakers can I use in front of my car?
We offer a great variety of replacements, including front door, front passenger side and rear side door radio speakers and twitters as well as windshield side garnish molding radio speakers. Our virtual shelves are loaded with quality speakers that will help you restore your vehicle audio system to its former glory without breaking a sweat.
