How do I make my trailer brakes work?
How do I make my trailer brakes work?
You will need to connect the red wire from the P2 brake controller to the cold side of the stop light switch. Use a circuit tester, item # 40376 if needed, and find the wire at the brake switch that has power only when the brake pedal is pressed. Connect the red wire to this circuit.
How does the brake system on an ATV work?
The brake system consists of these basic components that all work together: Hand Lever The rider pulls or squeezes the lever against the handlebar to operate the brakes. Pulling the lever will generally activate the brakes on all four wheels of the bike. Master cylinder Next, to the hand lever on the handlebar, you find the master cylinder.
Why do trailer brakes not work when in Park?
The most likely problem is that the controller is not getting the input that the vehicle brakes are being applied. When the trailer is hitched up with the transmission in park, use a circuit tester like part # 3808 on the red wire exiting the rear of the controller. You should show voltage on the wire when the trucks brake pedal is pressed.
When does The Prodigy brake control only work?
THE PRODIGY BRAKE CONTROL ONLY WORKS ON MANUAL. THE DISPLAY SHOWS .C. BUT WHEN PUSHING ON THE BRAKE NO NUMBERS COME UP AND BRAKES ON TRAILER DO NOT WORK. ADJUSTED PER INSTRUCTIONS SUPPLIED.
You will need to connect the red wire from the P2 brake controller to the cold side of the stop light switch. Use a circuit tester, item # 40376 if needed, and find the wire at the brake switch that has power only when the brake pedal is pressed. Connect the red wire to this circuit.
Do you need to calibrate a trailer brake controller?
With the trailer plugged in, the brake controller may need to be calibrated. Most brake controllers are self-calibrating. Others do not require calibration at all. Typically, self-calibrating brake controllers will flash a light or signal to indicate when the unit is calibrating and when calibration is complete.
How do you set sensitivity on Trailer Brake Controller?
Sensitivity is how aggressively your brake controller will apply the brakes. You can set sensitivity by testing the trailer brakes again. Drive forward at about 25 mph and press the brake pedal. If the vehicle stops too slowly, increase the sensitivity setting. If it stops too abruptly, lower the sensitivity.
What should the gain be on a trailer brake controller?
For larger trailers, use a higher gain setting. For smaller trailers, a lower gain setting should be used to avoid brake lockup. To set trailer brake gain, start with the values specified by the manufacturer. Test your trailer brakes at 25mph.
