Most popular

How do I know if my throttle cable is too tight?

How do I know if my throttle cable is too tight?

How do you know if your accelerator cable is bad?

  1. The pedal feels stiff or hard to depress.
  2. The pedal sticks and does not release normally.
  3. There is slack in the pedal’s movement.
  4. There is a rough or abnormally low idle.
  5. The engine stalls.
  6. There is a delay in response when you push the pedal down.

How do you tighten the throttle valve cable?

Keeping the cable relaxed, push in the D button with a screwdriver. When the D button is pressed, the cable housing can be moved closer to the throttle bracket to tighten the cable or further away to loosen it. Note: Make sure that the gas pedal is not being depressed while you are making the adjustments.

Where is the throttle valve on a Dodge Ram truck?

Between the throttle linkage and the driver’s side of the transmission there is a cable that causes a valve inside the transmission to move in relation to throttle position (gas pedal position). This cable is also referred to as the Throttle Valve (T.V.) cable.

How do you disconnect the throttle cable on a boat?

Use a screwdriver, pliers or a wrench, depending on the type of connection, to disconnect the throttle cable from the throttle. Move the throttle into the neutral position. Pull the throttle cable to its attachment point on the throttle.

Where does the throttle valve cable come from?

Average rating from 123,882 customers who received a Adjust Throttle Valve Cable. Many cars with automatic transmissions use a mechanical cable that runs from the transmission to the throttle linkage. This throttle valve cable is responsible for controlling the throttle lever providing movement to the car.

How do you adjust the throttle valve cable?

Tip: Consult the owner’s manual for any specifications for your car’s make and model. Adjust the cable by a small increment then have your helper press the gas pedal all the way down and check the cable at WOT. Lengthening the cable will allow the vehicle to shift earlier and the shift will be softer.

How do I reset the Dodge Ram throttle position sensor?

To reset the Dodge Ram throttle position sensor, you turn on the ignition without your foot on the brake, so the engine doesn’t start. Press the accelerator on the floor for 15 seconds. Release the accelerator, then turn the car off and start the engine and drive.

What kind of throttle control does a Dodge Ram use?

After the 2003 model year, Dodge Rams with the 5.7 Hemi engine began using “drive-by-wire” electronic throttle control. This article does not apply to those trucks. Before replacing the sensor, try the calibration procedure: Insert key into the ignition and turn the key to the “on” (not start) position. Wait for all of the warning lights to go out.

Where do you find the throttle linkage on a Honda Accord?

Step 2: Locate the throttle linkage. Before you can make any adjustments, you will need to locate the throttle valve adjustment location and the throttle linkage. Pop the hood and look for the intake piping. Follow the piping to the intake itself. You will find a series of linkages and cables mounted on the intake.

Author Image
Ruth Doyle