How can I tell if my Chevy Traverse is working?
How can I tell if my Chevy Traverse is working?
Make sure to check the harness where it plugs into both sensors as well. After examining the wiring harness, it would be time to check the sensors themselves. Using a simple voltage tester, you’ll be able to determine whether or not they are functioning correctly.
How does a crank sensor work on a traverse?
The Crankshaft Sensor is going to use a tone or reluctor ring to determine the position of the Crank. This ring uses notches that are scanned by the Crank Sensor in order to get an accurate position. If this ring fails, the Traverse will not be able to get an exact crank position.
What causes the crank position sensor to go out of alignment?
It is typically thrown when the Crankshaft Position Sensor and the Camshaft Position Sensor are out of alignment by a certain number of degrees, or if there is an issue with the wiring, or one of the sensors themselves may have gone bad. We’ll explore the symptoms and causes directly below.
What causes the crank on a Chevy Traverse to rattle?
The camshaft typically will have a ring that provides the same function. Often when a reluctor ring goes bad, it’ll rattle quite a lot. That is a very good indication that there is an issue with it. Here’s a good video on diagnosing P0017:
Where is the camshaft position sensor location on a traverse?
Please help us! Search the forum using the SEARCH button for “Factory Service Manual” which is a free download. Well, there are four (4) of them. Bank one intake and exhaust, bank 2 intake and exhaust. Located on front engine cover (belt side of engine) just at or below valve cover to cylinder head sealing line.
Are there any problems with the 2010 Chevrolet Traverse?
2010 Chevrolet Traverse. The 2010 Chevrolet Traverse problems were mainly in the categories of the engine, steering, and AC/heater. The main issues within the engine category of problems was engine failure, timing chain code issue, check engine light on, and engine losing power while driving.
What causes check engine light to come on on Chevy Traverse?
The car’s timing chain code issue costs around $2,600 to fix, which can be achieved by replacing the timing chain and related parts at around 94,500 miles. The check engine light typically comes on due to a faulty camshaft position, the timing chain needing to be replaced, or the needing to replace the timing belt and gears.
What’s the trouble code for the camshaft position sensor?
I have the same thing P0017 OBD-II Trouble Code: Crankshaft Position – Camshaft Position Correlation (Bank 1 Sensor B). The check engine light goes on and off but it runs rough and does not have power, some days are worse than others.
