How big are the king pins on a Chevy truck?
How big are the king pins on a Chevy truck?
King Pins. Double Duty, 2Ton, 46-47 1-1/2Ton, 48-57 1-1/2Ton heavy duty For 1946 1947 1948 1949 1950 1951 1952 1953 1954 1955 1956 1957 Chevrolet Trucks King Pins. 1/2Ton, 34-39 3/4Ton and 1Ton king pin .732″ dia. length 5-3/16″ busing OD. .860″ For 1929 1930 1931 1932 1933 1934 1935 1936 1937 1938 1939 Chevrolet Trucks
How do you remove a king pin from a front axle?
A bolt or stake goes through axle end to hit the flat spot on each king pin and hold them in place. This allows spindle yoke to swivel on the stationary pin. Final removal of old pin was done on 20-ton press using socket as spacer.
How do you lubricate king pins on a Dodge truck?
Lubrication of pins is accomplished by drilling holes in the yokes that are threaded on their upper (outside) end to accept a grease fitting. If you’re doing any job, including king pins, on a truck like this 1940 Dodge VC 1/2-ton pickup, you’ll be wise to visit www.39-47dodgetrucks.com.
Where do king pins go on a mower?
King pins slide through bearings in upper and lower ends of spindle yoke (and through holes on ends of axle). Pins fit as tight as possible without binding. A bolt or stake goes through axle end to hit the flat spot on each king pin and hold them in place.
King Pins. Double Duty, 2Ton, 46-47 1-1/2Ton, 48-57 1-1/2Ton heavy duty For 1946 1947 1948 1949 1950 1951 1952 1953 1954 1955 1956 1957 Chevrolet Trucks King Pins. 1/2Ton, 34-39 3/4Ton and 1Ton king pin .732″ dia. length 5-3/16″ busing OD. .860″ For 1929 1930 1931 1932 1933 1934 1935 1936 1937 1938 1939 Chevrolet Trucks
What’s the best way to replace kingpins in a truck?
Using oversized King Pins is a good alternative. Jack the truck high up, then heat up one location after another with a gasflame and spray CRC oil spray on top. I tried it the hard way first with hammers and an airpressure sissel , but that was`nt really working it sat so hard together and it would `nt move a bit.
What kind of suspension did a Chevy truck have?
For 1940 Chevrolet Trucks This is a kingpin kit for straight axle cars (except models CC, DC, EC & FC) king pin .732″ dia. length 5-3/16″ busing OD. .860″ For 1929 1930 1931 1932 1933 1934 1935 1936 Chevrolet Cars This is a kingpin set for knee action shock suspensions 1939-54 and 53-62 Corvette.
How do you remove grease from a kingpin truck?
The first thing to remove is the retaining bolts—and 2 inches of crud and 50 years of grease! I use a propane torch to heat the crud after I’ve scraped off all I can. Then wire brush the area until the metal is clean.
