Does JG Speedfit need inserts?

Does JG Speedfit need inserts?

The simple answer is yes, always use an insert when installing Speedfit pipes as it supports the shape of the pipe. We have two types of insert – the ‘STS’, or Superseal for plastic to plastic, and the ‘TSM’ for plastic to compression.

What is a Superseal pipe insert?

Description of the Superseal Pipe Insert To be used when connecting a Speedfit pipe to a Speedfit fitting. The 2 extra ‘O’ Rings provide enhanced sealing. Note: When connecting to a Compression fitting, standard TSM inserts must be used.

Do you need inserts when using plastic pipe?

While both types of pipe insert are suitable for hot and cold-water systems as well as underfloor heating and central heating, when using Speedfit pipe and fittings, a plain insert should always be used when plastic pipe is installed with a compression fitting.

Do you need inserts for push fit?

Pipe inserts are required on push fit and compression fittings when using plastic pipe. The inserts vary in size from one manufacturer to another ,so you should use the inserts relative to the pipe brand. Heat likes this.

What is a pipe insert?

Pipe Inserts (or Pipe Stiffeners as they are sometimes known) are used to strengthen the side walls of plastic water pipe when it is connected to push fit fittings. They are not required when connecting pushfit fittings to copper pipe as the pipe walls are strong enough to maintain their own shape.

Can you use plastic push fit on central heating?

Yes these plastic fittings can be used to join to new or existing copper pipework (not chromed pipe though), they are suitable for use on central heating as well as domestic water plumbing.

Can you use plastic pipe for hot water?

Plastic pipe systems are available in a wide variety of materials. These pipe systems can be used in hot and cold water supply and central heating installations; in fact in most areas where traditional piping materials are used.

What is the best plastic pipe for plumbing?

PEX. PEX piping is a flexible plastic piping that has become a popular selection in residential and small business applications. Although slightly higher initial cost, its minimal maintenance, and fast installation process make it the best pipe for water distribution inside a building.

Can I use push fit waste pipe with compression fittings?

Waste pipe compression fittings are very useful as they can be used to connect solvent weld pipe to push fit waste pipe. Because the compression waste fitting uses a tapered washer it can be used on either of the two pipes even with the couple of MM difference between the two.

When do you need a SuperSeal pipe insert?

Plumbers and installers must use a Speedfit pipe insert when working with our products. View Speedfit’s range of pipe inserts. What’s the role of a Superseal Insert then? A superseal insert adds an extra line of defence to fittings and pipes. What makes them unique is the fact that they feature two additional O-ring seals compared to plain inserts.

What makes a Speedfit plumbing insert so special?

What makes them unique is the fact that they feature two additional O-ring seals compared to plain inserts. One of these is located on the stem, which is pushed into the pipe to prevent water from inside the pipe passing between the inside of the pipe wall, and the outside surface of the insert.

When to use TSM inserts on Speedfit pipe?

To be used when connecting a Speedfit pipe to a Speedfit fitting. The 2 extra ‘O’ Rings provide enhanced sealing. Note: When connecting to a Compression fitting, standard TSM inserts must be used.

Can a JG pipe insert fit a 15mm pipe?

Yes they will I have just dun a test on JG’s inserts. I spoke to FloPlast technical today about there 15mm white PEX Barrier pipe he said all pips are set to a BS (some number) slandered so any insert or fittings will do.