Do You need Timing marks for a pointer?
Do You need Timing marks for a pointer?
Along with the pointer, you would need a harmonic balancer with timing marks in the right place for your pointer. Some aftermarket balancers have multiple sets of marks so that they can be used with a pointer on either side.
Where are the timing marks on a Ford 302?
Ford used several different timing pointer/harmonic balance sets on 302s depending on the year and what side the water pump inlet (lower radiator hose) was on. What side is the lower radiator hose on on your engine? Do you now what year the engine is? Here’s a picture of the “cast-in” pointer found on engines with a passenger-side-inlet water pump.
How to get timing marks on a 69 Mustang?
1. Get a balancer for a ’68-69 SBF or ’69 351W with passenger side water pump inlet (provided you have the correct pulleys) or, 1a. Buy and install a timing tape or, 2. Set you engine at TDC on #1 and mark your balancer to correspond with the driver’s side pointer TDC mark.
Where is the timing pointer on a Mustang?
As you have discovered, the pointer could be on either side. It was usually determined by the type of water pump installed. The lower radiator hose is on one side and the timing pointer is on the other.
Along with the pointer, you would need a harmonic balancer with timing marks in the right place for your pointer. Some aftermarket balancers have multiple sets of marks so that they can be used with a pointer on either side.
As you have discovered, the pointer could be on either side. It was usually determined by the type of water pump installed. The lower radiator hose is on one side and the timing pointer is on the other.
How do you make timing marks on a water pump?
Obtain the appropriate pointer for whichever side inlet your water pump has, so you can actually SEE the marks and then you can, after you determine TDC (a piston stop usually is best to use), scribe a corresponding line on your balancer and either attach a timing tape or measure the circumference and make your own marks based on 360* in a circle.
What do you need to know about timing gear clearance?
2153-06-03-01 Timing Gear Clearance, Checking (All) You must read and understand the precautions and guidelines in Service Information, Group 20, “General Safety Practices, Engine” before performing this procedure. If you are not properly trained and certified in this procedure, ask your supervisor for training before you perform it.
Where do I find the timing mark on my car?
With the engine off, open the hood and locate the crankshaft pulley. There will be a mark on the crankshaft pulley along with degree mark(s) on the timing cover. Tip: These marks can be observed while the engine is running by illuminating this area with the timing light to check and adjust ignition timing.
What do I need to adjust the timing on my car?
Your timing must be at the correct setting for your car to perform at top level, affecting the speed and efficiency at which the engine fires. You can adjust your car’s timing with a timing light and a set of wrenches, tools available at any auto parts store.
