Can you change the wheel bearings on a Volkswagen Jetta?
Can you change the wheel bearings on a Volkswagen Jetta?
The wheel bearings allow the wheels on your car to spin without too much friction and keep the rest of your wheel hub in good condition. The Volkswagen Jetta has sealed front wheel bearings. Although you cannot adjust them, you can replace them using the right tools. Pop the hood, and disconnect the negative battery terminal.
How do you change wheel bearings on a car?
To change wheel bearings, start by lifting the wheel up on a jack, unscrewing the lug nuts, and taking the wheel off. Then, remove the brake caliper, the dust cover over the rotor, and the cotter pin and castle nut behind the dust cover. Next, pull the rotor off, remove the old hub, and take apart the hub assembly to access the wheel bearings.
What’s the best way to replace a front wheel?
Use a glob of grease to coat the inner bearing race, then set the inner bearing down inside it. Take the inner wheel-bearing seal and install it as you did the bearing races, tapping it into place and taking care not to cock it, but only get it flush with the inner surface of the hub. Don’t pound it in any farther than that.
Where to put wheel chocks when changing wheel bearings?
For example, you would place wheel chocks behind the rear tires if you are fixing a front wheel bearing and behind the front tires if you are working on a rear wheel. Loosen the lug nuts and lift the wheel using a jack. For proper access to the internal components of the wheel whose bearings you’re replacing, you’ll need to elevate the wheel.
When did VW replace front wheel bearing 05-13?
It’s the same part and similar process on these Jettas from 2005 to 2009. We show you on the passenger side, but the driver side is the same procedure.
Can you replace front wheel bearings on a vintage car?
On many vintage cars, replacing front wheel bearings is synergistic with replacing the front rotors. This is because the front rotors are often behind the front hubs, which means that to change the rotors you have to pull the hubs off the front spindles, at which point the bearings are practically in your hand.
How do you remove the inner bearing from a wheel?
If the inner bearing sticks inside the wheel hub, clamp the wheel hub in a vise and use a bearing press to pull the inner bearing out. Pull out the old snap ring, and use the press tool to remove the bearing from the knuckle. Use a wire brush to clean inside the area where the bearing was.
The wheel bearings allow the wheels on your car to spin without too much friction and keep the rest of your wheel hub in good condition. The Volkswagen Jetta has sealed front wheel bearings. Although you cannot adjust them, you can replace them using the right tools. Pop the hood, and disconnect the negative battery terminal.
If the inner bearing sticks inside the wheel hub, clamp the wheel hub in a vise and use a bearing press to pull the inner bearing out. Pull out the old snap ring, and use the press tool to remove the bearing from the knuckle. Use a wire brush to clean inside the area where the bearing was.
What’s the best way to tighten a wheel?
Place the brake calipers on the wheel hub, and tighten them with a torque wrench according to the recommended foot-pound specifications. Attach the axle nut to the center of the wheel hub, connecting it to the axle, and torque it accordingly too. Put the wheel back on the bolts, and use the torque wrench to tighten the nuts holding it on.
