Can a timing chain be replaced with a water pump?

Can a timing chain be replaced with a water pump?

If this is the case with your engine, it is likely that you will need more than just a water pump/timing chain replacement. Your oil pan will need to be dropped, the engine flushed out, and the rod/main bearings inspected and or replaced, or replacement of the engine with a rebuilt unit.

Can a water pump be replaced on a Dodge Intrepid?

Now, here is what is involved and how to replace a water pump on a 2.7. This is not a job for the faint-of-heart, nor a job for those with no automotive knowledge. The car is a 2003 Intrepid with 73K miles. It began overheating randomly, and upon inspection I found water leaking from the water pump weep hole, just below the thermostat housing.

Where are the weep holes on a Dodge 2.7?

There are two weep holes on a 2.7, one is pictured, the other is below the lower intake manifold. If it leaks there, water will run out of the valley at the back of the engine and drip down around the transmission. These also have the potential to leak into the oil, and cause the oil to assume a “milkshake” appearance.

If this is the case with your engine, it is likely that you will need more than just a water pump/timing chain replacement. Your oil pan will need to be dropped, the engine flushed out, and the rod/main bearings inspected and or replaced, or replacement of the engine with a rebuilt unit.

Now, here is what is involved and how to replace a water pump on a 2.7. This is not a job for the faint-of-heart, nor a job for those with no automotive knowledge. The car is a 2003 Intrepid with 73K miles. It began overheating randomly, and upon inspection I found water leaking from the water pump weep hole, just below the thermostat housing.

There are two weep holes on a 2.7, one is pictured, the other is below the lower intake manifold. If it leaks there, water will run out of the valley at the back of the engine and drip down around the transmission. These also have the potential to leak into the oil, and cause the oil to assume a “milkshake” appearance.

Where to put the sprocket on a 2.7 water pump?

Set your sprocket on the front of the camshaft, and let it float for now, with no bolts in. Line up the single plated link on your timing chain with the slot cut into the crankshaft sprocket.

How big are the bolts on a dodge water pump?

Tighten the 6 water pump retaining bolts to 105 inch lbs. Now, it is time to install your inner (small) left and right timing chain guides. Tighten the bolts to 28 ft lbs.

Tighten the 6 water pump retaining bolts to 105 inch lbs. Now, it is time to install your inner (small) left and right timing chain guides. Tighten the bolts to 28 ft lbs.

Where is the weep hole on a Dodge 2.7 water pump?

It would only leak at certain times. There are two weep holes on a 2.7, one is pictured, the other is below the lower intake manifold. If it leaks there, water will run out of the valley at the back of the engine and drip down around the transmission.

It would only leak at certain times. There are two weep holes on a 2.7, one is pictured, the other is below the lower intake manifold. If it leaks there, water will run out of the valley at the back of the engine and drip down around the transmission.