Are there any problems with Chevy Colorado door locks?

When I reconnected battery, I used key started truck and at 20 mph the locks worked like normal. 😆 GM has issued a technical service bulletin (TSB) #PIT3164B to discuss a problem with door locks and power windows on 2004-09 Chevrolet Colorado pickups and 2004-09 GMC Canyon Pickups.

Why does my Colorado window lock not work?

The resistor and connector is an easy fix with the link ssgjurista gave you. I think the problem is the contacts between the two most times rather than the resistor itself.

Are there any problems with my Chevy Colorado?

GM has issued a technical service bulletin (TSB) #PIT3164B to discuss a problem with door locks and power windows on 2004-09 Chevrolet Colorado pickups and 2004-09 GMC Canyon Pickups. The problem shows up as inoperative or intermittent door locks or power window operation.

Where is the power window on a Chevy Colorado?

It is located in the engine bay, on the left side aft of the battery. Remove the one attach bolt and clean the mating surfaces of the box tab and the fender wall and remount the box. You don’t need to open the box at this time, but it wouldn’t hurt to check in there for corrosion.

Why is my power window not working on my Chevy Colorado?

The problem shows up as inoperative or intermittent door locks or power window operation. In many cases, fuse #42 in the underhood fuse box may blow. GM has identified two scenarios that would blow this fuse: 1) The fuse blows when opening/closing power windows and using the door locks at the same time.

Why is my power door lock not working?

Power door locks are not working and the driver side power window is not working. All stopped working at same time. Checked fuses and they looked ok. If anyone could help with some suggestions?

Why are the locks not working on my Chevy Colorado?

Anyhow, turns out my battery was fine, but when I reconnected it the driver’s side window would not go up or down, and the power locks would not work. Pressing either button on the key fob would flash the headlights, and you could hear a relay under the hood clicking, but nothing on the locks.

Power door locks are not working and the driver side power window is not working. All stopped working at same time. Checked fuses and they looked ok. If anyone could help with some suggestions?

How to fix driver side power door lock?

1. disconnect the battery and connect both the positive and negative cables together(after disconnected)) 2. disconnect the window and lock controller in the driver’s side door. 3. Leave cables connected for at least 5 minutes 4. Re-connect door window controller and locks wiring harness 5.

Where are the power locks on my car?

There is a single relay that controls both the power locks and the driver’s side window, located inside the driver’s side window switch. It can get stuck open, either from the BCM sending it into safe mode or, in my case, I think, because of extreme cold.