Will disconnecting battery reset security system?
Will disconnecting battery reset security system?
Start by removing the battery’s negative cable and leave it disconnected for five minutes then reconnect the battery. This will allow the security system to perform a hard reboot and reset the alarm protocol to help the immobilizer start working in the proper sequence.
How to turn on security light without starting engine?
Turn key to the “ON” position without starting the engine. Security light should turn on and stay on. Turn key to the “ON” position without starting the engine. Security light should turn on and stay on. Turn key to the “ON” position without starting the engine. Security light should turn on and stay on. Turn key to the “OFF” position.
When do I need to relearn the security key?
Start the If the vehicle starts and runs normally, the relearn is complete. If additional keys need to be relearned: Insert the next key to be Turn the key to the “ON” position within 10 seconds of removing the previously used key. Wait for security light to turn It should happen fairly quickly.
How do you turn off the security light?
Insert the master key with the black head into the ignition lock cylinder 2. Turn the key to ON but do not start the engine. The SECURITY light will turn on and stay on. 3. Wait 10 minutes or until the SECURITY light to turn off. 4. Turn the key to OFF for 5 seconds. 5. Turn the key to ON but do not start the engine.
How to reset the PassLock 3 security system?
Turn the key to ON but do not start the engine. The SECURITY light will turn on and stay on. 3. Wait 10 minutes or until the SECURITY light to turn off. 4. Turn the key to OFF for 5 seconds. 5. Turn the key to ON but do not start the engine. The SECURITY light will turn on and stay on. 6. Wait 10 minutes or until the SECURITY light to turn off. 7.
Turn key to the “ON” position without starting the engine. Security light should turn on and stay on. Turn key to the “ON” position without starting the engine. Security light should turn on and stay on. Turn key to the “ON” position without starting the engine. Security light should turn on and stay on. Turn key to the “OFF” position.
Start the If the vehicle starts and runs normally, the relearn is complete. If additional keys need to be relearned: Insert the next key to be Turn the key to the “ON” position within 10 seconds of removing the previously used key. Wait for security light to turn It should happen fairly quickly.
How do I Turn Off the PassLock security light?
1. Turn the key to ON and attempt to start the engine and release the key to the ON position. 2. The SECURITY light will illuminate. Wait 10 minutes until it turns off. 3. Turn the key to OFF for 10 seconds. 4. Turn the key to ON and attempt to start the engine. If it starts and run, the system has reset.
How long does it take for security light to turn off?
Insert ignition key and turn to the “ON” position. Do not attempt to start the engine. Leave the key in the “ON” position for approximately 11 minutes. The security light will be steady on or flashing for the 11-minute period. Do not proceed to Step 2 until the security light turns off or stops
