Why is my John Deere transmission not working?

If the transmission oil is too cold, it can result in the machine not working correctly. In cold weather it is advised that the engine be allowed to warm up before the machine is used. Transmission issues should be diagnosed by a John Deere repair retailer.

Can a John Deere 450C have a powershift?

If it is a John Deere 450C it is not a powershift. It has a four speed gear type transmission which has a shifting lever for selecting one through 4. A second shift lever is for high foreword, low foreword, low reverse and high reverse.

What is the second shift lever on a John Deere 450?

A second shift lever is for high foreword, low foreword, low reverse and high reverse. There is a conventional disk type clutch in the system which is activated by the clutch pedal with the operator’s foot. The high/low/foreword/reverse shuttle is a hydraulic type clutch separate from the standard clutch.

Is the pump on a John Deere 450 bad?

The pump on a 450C is a real bit– to change as is everything on a 450C. They are the worst machine to work on I have ever seen. Even the Deere Dealer techs say so. I have two 450A track loaders trying to make one good machine. Is it just me or are John Deere parts hard to get. Somethings are available, other parts no one even wants to look for.

When did the JD 350C reverser come out?

Last edited by LeonardL on Sat Dec 31, 2011 3:09 pm, edited 1 time in total. 40 plus years working on JD 350s, 400Gs, 450s and other equipment both Ag and Construction. Correct me if I a wrong, but I belive most dozer machines were equiped with a reverse gear in the transmission where are loader machines were not.

What causes a tractor loader to quit lifting?

The loader just up and quit lifting, though the bucket will curl and the three-point works fine. There’s fluid going to the barrel side of the rams, but not to the shaft sides.

What kind of tractor won’t lift dirt?

My father-in-law has a JD 790 with a 419 loader that i’ve been using to move some dirt around. The loader just up and quit lifting, though the bucket will curl and the three-point works fine.

How do you jam a tractor in float mode?

Someone else told me they though it might be in float mode, but if that’s the case, i would think it has to be jammed in that mode via the SCV. It won’t lift the front of the tractor. You can curl the bucket so it does and then hit the lift lever and it will expand the lifting cylinders, but it won’t squeeze them closed.

What to do when your john deere won’t move?

-When reassembling the transmission to the frame, lift the transmission about half way up and then set your belt back in the pulley track with the v side to the inside of track. Again use the brake to give it some slack. Once it’s in the track you can put the guide post back in and release the parking brake.

What’s the pressure on a John Deere backhoe?

Cat 416d standard transmission won’t move cold. No oil pressure at test port by trans oil filter. Once trans is about 60 degrees F. machine moves forward and reverse. Pressure is 185 psi at 2000 rpm t … read more I have a 1986 john deere 210c backhoe. It has 4 gears with I have a 1986 john deere 210c backhoe.

Can a Deere loader move in either forward or reverse?

HAve deere 544a, loader won’t move in either forward or reverse. Appears to be in gear, just doesn’t move. Hydraulic HAve john deere 544a, loader won’t move in either forward or…

Why does my 544g not engage the transmission?

Now it or the other machine ( 544G ) will not engage the transmission. Called JD dealer and they said that it was the Ground speed sensor, so I got a new one with wires and replaced it. Still won’t move. Next they said it could be the shift controller and I replaced it and still the same?. I swapped the computers and that did nothing.

What’s the problem with a JD 544g wheel loader?

Discussion in ‘ Wheel Loaders ‘ started by flyboyziel56, Jan 6, 2010 . OK I need some help from you JD Techs!!. Found the start problem with the 624G and it was the solenoid not disengaging from the Bendix. Now it or the other machine ( 544G ) will not engage the transmission.

What to do if your John Deere tractor won’t move?

John Deere Lawn Tractor Won’t Move – 5 Minute Fix! If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.

Why is my John Deere transmission not working?