Easy lifehacks

Why is my GMC Sierra 1500 stalling out?

Why is my GMC Sierra 1500 stalling out?

No change. Next, read somewhere that bad ground wire on Thermostat housing can cause ECM issues. Checked it, cleaned it off, verfied that contact wanhers are all steel and attract a magnet, reinstall the ground wire.

What causes hesitation and stumbling in a 1990 Chevy c1500?

An expert that got 10 achievements. Re: 1990 chevy c1500 hesitation and stumbling during… Based on what you said, I would say the engine is starving for fuel. The computer has to be disabled to set timing – there should be a procedure for that. I would start with checking fuel pressure at the throttle body.

Are there any changes to the GMC Sierra 1500?

New distributor comes with new ESC electronic unit, pickup coil, cap & rotor, also. No change. Next, read somewhere that the fuel pressure regulator diaphram if split could cause flooding. rebuilt throttle body unit, rebushed it and boiled it out and added rebuild kit and brand new Borg Warner injectors.

What kind of engine did a 1990 Chevy truck have?

1990 Chevrolet C1500 — 350 V8 TBI — Regular Cab, Short Bed, 2 wheel drive, 89000 miles. New parts: EGR valve, coolant temperature sensor, fuel filter, idle air control valve, pcv valve, air filter, 1 oxygen sensor (in the exhaust manifold), spark plugs, distributor cap and rotor.

Why does my GMC Sierra suddenly stop running?

Truck suddenly stops running, acting like it’s out of fuel. There is fuel in the gas tank and, I can hear the fuel pump when I turn the ignition on. Is there a fuse, or relay that is maybe causing this to happen?

What was the problem with my 1990 Chevy k1500?

My old 1990 K1500 had the same stalling problems until I changed the EGR valve. We have a 1990 2wd 350 tbi with similar issues. So far it has a new distributor (for an unrelated problem), idle valve, throttle position sensor, knock sensor, temperature sensor, fuel filter, plugs & wires.

An expert that got 10 achievements. Re: 1990 chevy c1500 hesitation and stumbling during… Based on what you said, I would say the engine is starving for fuel. The computer has to be disabled to set timing – there should be a procedure for that. I would start with checking fuel pressure at the throttle body.

What to do if your GMC Sierra stall out?

69 people found this helpful. I have a 98 gmc searria 4×4 i checked fuel pressure it was under i changed fuel pump and fuel filter and its still starving for fuel what to do it starts with starting fluid 42 people found this helpful.

What kind of engine does a 2003 Silverado have?

Here’s the kicker…..I put the new one in and the truck started right up and we thought it was fixed, my son drove the truck and it ran fine, but when he returned home, it wouldn’t keep running after he would try to start it again, no matter how many times we tried.

Why did my Silverado engine die after 9 months?

Turns out that the wiring harness to the ECM had fallen down onto the motor, melted the loom, and shorted the ECM out occassionally. It only took 9 months to figure this out, but it did the trick. It was extremely frustrating as it would run like a champ one day, and die the next.

No change. Next, read somewhere that bad ground wire on Thermostat housing can cause ECM issues. Checked it, cleaned it off, verfied that contact wanhers are all steel and attract a magnet, reinstall the ground wire.

Here’s the kicker…..I put the new one in and the truck started right up and we thought it was fixed, my son drove the truck and it ran fine, but when he returned home, it wouldn’t keep running after he would try to start it again, no matter how many times we tried.

New distributor comes with new ESC electronic unit, pickup coil, cap & rotor, also. No change. Next, read somewhere that the fuel pressure regulator diaphram if split could cause flooding. rebuilt throttle body unit, rebushed it and boiled it out and added rebuild kit and brand new Borg Warner injectors.

What should I do if my Silverado engine dies?

Update as of today: 1) the truck hasn’t started and kept running since last week. It only starts right up, then dies immediately. 2) I got a fuel pressure tester and the pressure is at 53 with key on, and maintains pressure when it starts (then dies).

Checked it, cleaned it off, verfied that contact wanhers are all steel and attract a magnet, reinstall the ground wire. No change. Next, read somewhere that Engine Coolant Temp Sensor if malfunctioning could cause the ECM to think the engine is at -40 deg F in dflt mode.

Why does my GMC Sierra 1500 not shift gears?

GMC Sierra 1500 Questions – Speedometer doesn’t work and transmission doesn’t shift gears. – CarGurus Speedometer doesn’t work and transmission doesn’t shift gears. The speedometer stays at 0 all the time. When the transmission is in drive it won’t come out of 1st gear.

Why does my speedometer not work on my GMC Sierra 1500?

– CarGurus Speedometer doesn’t work and transmission doesn’t shift gears. The speedometer stays at 0 all the time. When the transmission is in drive it won’t come out of 1st gear. Reverse works fine, and if I manually put the transmission in 1st or 2nd it works fine.

What kind of truck won’t shift out first?

52 people found this helpful. 2003 Sierra-My truck is doing the same thing- speedo reads zero and won’t shift out of first.

Why does my GMC Suburban no start flooding itself out?

If I unplug one of the injectors it starts up and idles and I am able to plug the injector back in and it will idle as normal. If I try and start it with both injectors plugged in, it just cranks and cranks without attempting to start.

Checked it, cleaned it off, verfied that contact wanhers are all steel and attract a magnet, reinstall the ground wire. No change. Next, read somewhere that Engine Coolant Temp Sensor if malfunctioning could cause the ECM to think the engine is at -40 deg F in dflt mode.

GMC Sierra 1500 Questions – Speedometer doesn’t work and transmission doesn’t shift gears. – CarGurus Speedometer doesn’t work and transmission doesn’t shift gears. The speedometer stays at 0 all the time. When the transmission is in drive it won’t come out of 1st gear.

– CarGurus Speedometer doesn’t work and transmission doesn’t shift gears. The speedometer stays at 0 all the time. When the transmission is in drive it won’t come out of 1st gear. Reverse works fine, and if I manually put the transmission in 1st or 2nd it works fine.

How long has my Silverado Sierra been running?

We have had it for about 9 mos and put about 7k on it. Last week it started randomly stalling/dying, most times starting right back up. Then it died on my son and wouldn’t start. NO engines popping up. When I got to it I tried to go through the basics of troubleshooting- Turned on key to listen for fuel pump, pump came on.

Why is my Silverado Sierra engine popping up?

NO engines popping up. When I got to it I tried to go through the basics of troubleshooting- Turned on key to listen for fuel pump, pump came on. Pulled spark plug to check for spark which it had however plugs were bad and the spark was orange instead of blue.

What happens when you take your foot off the gas pedal?

Engine dies when I take my foot off gas pedal. lexus engi… Q: Engine dies when I take my foot off gas pedal. The engine dies when I take my foot off of the accelerator. Hello. If the engine runs fine when you are holding the accelerator pedal down and dies when you release it then you may have a couple of possible issues.

Why does my GMC Sierra stall when idling?

Stalling continues and now more often when idling, warm or cold. During idling the engine sputters and surges before it stalls. The dealer ship figures that the stalling and the PRV are two seperate issues. The only code that comes up is the faulty PRV.

Why does my Chevy Silverado stall in reverse?

Sounds alot like a bad ground and/or battery connection problem. THe stalling in reverse could be caused by the movement of the engine in the opposite direction due to the reverse torque combined with a loose ground cable on the engine. Hope this helps.

Why does my car stall at low rpm?

The will likely force your computer to stall the engine and only allow it to run at low RPMs, which means the car will only move at slow speeds. This is a safety feature enforced by the computer so that your engine doesn’t get too damaged.

Why does my truck stall when I make a left turn?

Messages: 97. If it’s stalling due to the additional load applied by power steering at idle (foot off accelerator) then the engines idle control system could be at fault. Also with the heater changing this could be a vacuum problem.

Author Image
Ruth Doyle