Why does my Monte Carlo shift hard when I stop?
Why does my Monte Carlo shift hard when I stop?
It is when I come to a complete stop and then start to accelerate it shifts hard when first starting off. This only happens after about thirty minutes of driving and then if I shut off my car for a couple hours it shifts fine again for the first thirty minutes of driving. Can someone help me what the problem is???
How long does it take to turn off a GM security light?
Leave the key in the “ON” position for approximately 11 minutes. The security light will be steady on or flashing for the 11-minute period. Do not proceed to Step 2 until the security light turns off or stops flashing. 2. Turn the ignition switch to the “OFF” position for 30 seconds. 3.
Is there a problem with the Monte Carlo Trans?
The problem is not the 3800, it’s that the 3800 is too strong, it’s the transmission that wasn’t built good enough to combine w/ the 3800. There is a fix for this though. The 4t65 trans can be upgraded to a Heavy-Duty version.
What should I do if my Toyota Corolla security light goes off?
The ten-minute procedure involves trying to start the engine. If nothing happens or the engine starts and dies, the security light will be flashing. Wait ten minutes. The flashing light should go off or illuminate without flashing. When it does, turn the ignition off, wait twenty seconds, and then try to start the engine.
It is when I come to a complete stop and then start to accelerate it shifts hard when first starting off. This only happens after about thirty minutes of driving and then if I shut off my car for a couple hours it shifts fine again for the first thirty minutes of driving. Can someone help me what the problem is???
The problem is not the 3800, it’s that the 3800 is too strong, it’s the transmission that wasn’t built good enough to combine w/ the 3800. There is a fix for this though. The 4t65 trans can be upgraded to a Heavy-Duty version.
What kind of sound does a Monte Carlo make?
I have a 2002 Monte Carlo SS with 135K miles. Ever since it had about 20K miles on it you could hear a ticking or tapping sound after it warms up. Sound is only noticeable at idle.
I have a 2002 Monte Carlo SS with 135K miles. Ever since it had about 20K miles on it you could hear a ticking or tapping sound after it warms up. Sound is only noticeable at idle.
Why does my Chevy Monte Carlo not shift?
Like a slip. When changing into third or fourth (whatever the last gear is) it makes a little skip. sometimes the starting from stop, it CLUNKS loudly. transmission fluid changed, but still does it. Lately, the car is having large difficulties shifting, or won’t shift at all.
Is there a problem with my Monte Carlo?
I haven’t driven my car alot yet so I will let you know but I read on MSN autos that this is a common problem on 2000 and 20001 monte carlo ss’. I experienced the same issue with my husband’s 2000 Monte SS. After about a 1/2hr or so, the car would begin to shift ‘hard’.
Why did my pressure solenoid go out on my Monte Carlo?
The pressure solenoid went out on my monte at 88500 miles. shifting became erratic and eventually it failed to shift at all. complete rebuild had to be accomplished due to over pressures screwing everything else up. Hard shifting. Smooth at takeoff but hesitates to go in gear after stopped.
What kind of transmission does a Monte Carlo have?
I’ve got a 1998 Chevy Monte Carlo Z34 automatic with front-wheel drive. The other day the transmission decided to get mad at me. Here’s the situation – When I was at a stop then accelerated, the car would shake a little and take a second to shift and move forward.
When does transmission shift hard from 1st to 2nd Rd?
When car transmission Fluid is low or dirty is could lead to transmission shifting hard from 1st to 2 nd and even from 2nd to 3 rd. So when you have a gear shifting issues, one of the things to check is your transmission fluid.
Why is it so hard to shift gears?
The automatic shifter has numerous sensors that regulator when and how the transmission changes gears. When anyone of this sensors is bad it hard to shift gear. So if the sensors fail to receive and send the right signal readings, shifting problems can occur due to the wrong signal transmission.
Why does my Monte Carlo shift hard to second gear?
Our technicians tell us that partial dis-assembly of the transmission is necessary to replace a failed pressure control solenoid. had the transmission fluid and filter changed in my 2000 monte carlo now it hesitates and shifts hard from drive to 2nd gear only.HELP PLEASE. Starting at a stop light, it jumps from first into second. Like a slip.
When car transmission Fluid is low or dirty is could lead to transmission shifting hard from 1st to 2 nd and even from 2nd to 3 rd. So when you have a gear shifting issues, one of the things to check is your transmission fluid.
Is there a problem with my Monte Carlo transmission?
I have a 2001 Chevy monte carlo ss. I have never had problems with my transmission until now. When I first start it up it shifts great and accelerates great. After about 30 minutes of driving it starts to shift hard in first and second gear. It is when I come to a complete stop and then start to accelerate it shifts hard when first starting off.
What causes a car to be hard to shift gears?
Hard shifting with manual transmission usually has to do with a problem in the gear system or with the clutch. Either one of the parts of the gear system is damaged or it is just completely worn out from too much use. Below are five of the most common causes of a manual transmission being hard to shift gears. 1) Damaged Master Cylinder
What’s the problem with my 2005 Monte Carlo?
2005 Monte Carlo shifting extremely hard on initial takeoff from a complete stop. About every 3-4 weeks car jerks violently forward. Once out of first gear, the car runs smoothly. Took the car to a Chevy dealership who was able to duplicate the issue and confirmed problem with the valve body.
I’ve got a 1998 Chevy Monte Carlo Z34 automatic with front-wheel drive. The other day the transmission decided to get mad at me. Here’s the situation – When I was at a stop then accelerated, the car would shake a little and take a second to shift and move forward.
2005 Monte Carlo shifting extremely hard on initial takeoff from a complete stop. About every 3-4 weeks car jerks violently forward. Once out of first gear, the car runs smoothly. Took the car to a Chevy dealership who was able to duplicate the issue and confirmed problem with the valve body.
What happens when you have a bad Shift Solenoid?
Erratic shifting or shift slippage: The shift solenoids regulate the flow of hydraulic fluid for shifting. A problem with one or more of the solenoids can cause a lack of pressure, resulting in hard, soft or delayed shifts.