Why does my cat th360b telehandler Ser look foamy?
Why does my cat th360b telehandler Ser look foamy?
Just make sure the oil level is up and it does not have water in the oil. It will look milky if it does have water in it. If it appears foamy, you could have an air leak but, it should not bring the machine to a stop. Drain a little out, the water would be on the bottom by now.
When does a cat telehandler go into passive mode?
When the machine is in-gear with the park brake disengaged, Cat Telehandlers enter passive mode. This means the LSI sensor will alert the operator to potential instability, but won’t lock out the hydraulics.
How can I get my Cat telehandler SER to work?
Try holding the boom control in the full retract position and the rock the steering wheel to see if the hydraulics will come back. Pump the brakes with the action to see if it will make it work. I have done this to get the pump to upstroke long enough to get the cylinders back in place so the unit could be sent to the shop.
How much does a Caterpillar CAT th360b weigh?
No longer in production, the CAT TH360B telehandler is powered by a 99.9 HP CAT 3054E engine, it has an operating weight of 9440 kg (20, 800 lb with a rated load capacity of 3100 kg…
Why does my cat th360b have a problem?
You could have a pump failure or the priority valve stuck open. Try the rocking motion on the steering and brake pedal pumping to see if you can jolt the priority spools back to thier seat and build pressure again. If it comes back the problem may only be in the main valve were these priority valves are located.
When is the auction for the telehandler th360b?
(SURPLUS TO CONTINUING OPERATIONS) FOR AUCTION: JCB 508C Telehandler, 1300×24 Solid Tread Tires, 8,000 lb. Capacity, VIN SLP508C0YE0586843, 4-Wheel Steering, 4WD, 3-Stage Boom THURSDAY, JULY 15TH AT 10 AM ET WEBCAST ONLY NO ONSITE BIDDING ALL EQUIPMENT WILL BE DISMANTLED & LOADED FREE OF CHARGE!
Try holding the boom control in the full retract position and the rock the steering wheel to see if the hydraulics will come back. Pump the brakes with the action to see if it will make it work. I have done this to get the pump to upstroke long enough to get the cylinders back in place so the unit could be sent to the shop.
