Why does my blend door actuator make noise?
Why does my blend door actuator make noise?
The symptoms of a bad blend door actuator include a lack of heat or air conditioning, or failure of air to blow through some or all of the vents. The actuator motors may also make a noise if they’ve failed, but this isn’t always the case. Of coarse the actuator does not achieve the commanded position.
Why does my 08 Impala make a clicking noise?
If You hear a clicking noise under the dash of Your Chevy Impala that is most commonly a problem with a component in the HVAC system for the car. It could be a blend door actuator, or the blower motor itself having a problem.
Why is my Blend door actuator making a clicking noise?
My blend door actuator was making that clicking noise. I bought a new one from oreilly auto parts and installed it and immediately it started making the same clicking noise. Its like I never even changed it. I know its the actuator making the noise I can put my fingers on it and feel it. Anyone ever had this problem?
How to replace an automotive blend door actuator?
Before installing the new actuator it’s a good idea to manually turn the blend door in both directions to ensure it is not stuck which will cause the new actuator to fail. Grasp the door pivot and move it back and forth to its full travel, it should move freely.
Is the blend door actuator still working on a Dodge Avenger?
It still clicks. It will start clicking when the car is off even. You could walk by it and you’ll hear it clicking, BUT the moment you open the door any door it will quit. When you start the car it will go off for about 15 seconds then stop.
Is there a problem with my Blender actuator?
Knocking: This is an unusual symptom, but if you’re experiencing this, it’s almost definitely a problem with your blender actuator. When you start the car, or just the AC system, and notice a knocking sound like someone tapping on your door, that is indicative of a problem with the blend door actuator.
When do I replace blend door actuator in 2008 Impala?
Chevrolet Impala LT: when i replace blend door actuator in… My heater controls in my silverado are not working properly, it is only hot on 90. You turn it down to 89 and it goes cold. I watched the blend for … read more Vocational, Technical or Tra… I’m about to replace the passenger side blend door actuator.
Where is the hot / cold blend actuator on an Impala?
The hot/cold blend door actuator is above the right side of the hump, exactly opposite the one on the driver’s side. The recirc actuator is behind the right side of the glove box. These 3 (2 hot/colds and 1 recirc) are all the same part number.
My blend door actuator was making that clicking noise. I bought a new one from oreilly auto parts and installed it and immediately it started making the same clicking noise. Its like I never even changed it. I know its the actuator making the noise I can put my fingers on it and feel it. Anyone ever had this problem?
Why does my Impala click when I plug in the actuator?
I can plug the actuator in let it sit on the open glove box and it does not make a sound. But when it is connected and installed to its original location the clicking starts again. This is the same for the new and old actuator. The one you got is bad then.
