Why does my 2004 Ford Explorer not start?

We replaced the battery on a 2004 Ford Explorer. The dash lights and headlamps all work fine but the truck will not start. There is not even any … read more Associate of Occupational i…

Why does my Ford Explorer alarm not go off?

Vocational, Technical or Tra… The anti theft light flashes very quickly when I turn the key to start my 2004 ford explorer. Car will not start, lights work, etc. … read more I have a 98 Explorer (2dr) and the alarm won’t turn off. I have flashing lights and a siren that goes off. Any answers? … read more Vocational, Technical or Tra…

What’s the problem with my 2002 Ford Explorer?

My 2002 ford explorer won’t start I changed my starterd and my battery and my alternater it still won’t start now my 2002 ford explorer won’t cut off when I turn the key ignition switch off what the problem please help me out 10 people found this helpful. Roll driver window down, get out lock door with key, remove key.

Is the anti theft light on my Ford Explorer broken?

I’ve done a little more “research” and found older vehicles with tilt wheel steering column are known to have broken wire issues. On my Explorer the transceiver has 4, wires going into a white plastic connector under the dash. The far right wire was broken on mine.

Why does my Ford Explorer have a theft light?

My Explorer was doing the intermittent theft light thing just like the rest of you. When I went to put in the new part I found that one of the wires that goes into the plug that is under the dash was broken. This break is was without a doubt caused by the wire being moved every time that you tilt the steering wheel.

When was the last time my Ford Explorer failed to read the chip?

The last time my 2001 Explorer failed to read the chip I just bumped the steering wheel a couple times to send vibrations through the column. It worked. Probably same effect as mentioned above by Sandra. The Ford mechanic said the “reader” will eventually fail all together and will need replaced. 51 people found this helpful.

Where are the wires on my explorer transceiver?

On my Explorer the transceiver has 4, wires going into a white plastic connector under the dash. The far right wire was broken on mine. The wires are left to right: black/w-white stripe, red (it may have a stripe I can’t see it in my photo) violet/w-blue stripe, tan/w- white stripe.

Why is my Explorer 4.0 engine not cranking?

05 explorer 4.0 just did a engine replacement got every thing hooked up but it won’t crank or start but if I cross the starter it’ll turn over. Message center on dash says engine service fail mode what ever that means any ideas?

What makes a Ford no crank no start?

You’ll see that the system consists of a fuse, ignition switch, starter relay, transmission range selector (neutral safety switch on for an automatic transmission) or a start inhibit switch for a manual transmission, and a ground control circuit provided by the PCM. The PCM gets involved here because of the ford passive anti-theft system (PATS).

What to do if your engine is not cranking over starter?

Friend with me checked fuses seemed okay. Turned key to on crossed starter, engine turned over but would not start. He suggested either ignition switch bad or a neutral switch. Any ideas and to figure out if ignition switch or neutral switch?

Why does my Ford 4.0L explorer not start?

So, when your Ford 4.0L Explorer (Aerostar, Ranger or Mountaineer) Cranks but Does Not Start, it’s because one of these components is missing from the mix.

What’s the problem with my 2004 Ford Explorer?

I have a 2004 Ford Explorer with a starting problem. twice when I went out to go home in the evening, it would not start. It would turn over and over … read more 2004 Ford Expedition horn keeps sounding (alarm) when I enter the car. We lost the “fob”. The key in the ignition, on and off, won’t shut off … read more Vocational, Technical or Tra…

Where is the overide light on a Ford Explorer?

Put the key in the ignition, and turn forward all the way just before cranking. Then within 5 seconds, locate, press and hold in the valet/overide button, found under the dash area, (push button, spring loaded) until the installed LED (the blinking light) in your dash area goes on solid, and the siren chirps once.

We replaced the battery on a 2004 Ford Explorer. The dash lights and headlamps all work fine but the truck will not start. There is not even any … read more Associate of Occupational i…

What to do if your Ford dashboard light comes on?

Make an appointment with your local dealer as soon as possible. Charging System: If you’re driving while this light comes on, switch off all unnecessary electrical equipment that you may have running and get your vehicle checked by an authorized mechanic immediately.

What do the warning lights on a Ford car mean?

Not all warning lights indicate a massive, immediate problem with your car. Each Ford instrument cluster is loaded with warning lights and notifications, and not all are bad. Knowing what your dashboard is trying to tell you may prevent that panic attack the next time a warning light flips on.

Where is the transponder on a Ford Explorer?

The transponder is located on the steering column around the lock cylinder. The trim around the steering wheel will need to be reomved. The Vehicle Security module is located behind the left rear seat behind the trim panel on the right side.

What to do when File Explorer won’t open?

Here are some things to try if File Explorer won’t open. Select the Start button > Settings > Update & Security > Windows Update . Then select Check for updates. Install any available updates and restart your device if required. Even if you don’t see updates that require restarting, doing so ensures that any pending updates are installed.

How can I tell if my starter motor is working?

Read the battery voltage using a voltmeter and make sure that it has enough charge to operate the starter motor. Your battery should have close to 12.6 volts with the engine off. Examine the connections between the battery and the starter and make sure that they are tight and clean. Loose or dirty connections will prevent proper current flow.

What makes a Ford 4.0L engine not start?

This tutorial is geared toward a Cranks but Does Not Start Condition. To successfully troubleshoot the cause of the no start condition of your Ford 4.0L equipped car or mini-van, you need to know that there are three very basic components the engine needs to start and they are: Air. Fuel.

What causes a car to have no start?

The engine pistons and cylinder head valves (and all the other related components like: timing chains, etc.) are the ones responsible for the induction of the fresh air the engine needs for the combustion process. Although rare, internal engine mechanical problems can and do cause No Start Conditions.

What to do if your Ford Explorer starts Hot?

Then troubleshoot the engine coolant temperature sensor and engine control system. If the starting system only gives you trouble when the engine is hot. check the fuel filter and make sure the fuel injection system is receiving fuel. In rare cases, the fuel system may be experiencing vapor lock.

What to do when your car won’t start?

When attempting to start the engine, make sure the transmission is in Park (P) or Neutral (N). Also, check the starting circuit for broken, loose or disconnected wires and cables from the battery to the starter solenoid, the ignition switch and the starter motor.

What does it mean when your Ford Explorer won’t start?

The first and most common is when it won’t turn over. This just means that the engine doesn’t move when you turn the key. The second way that your Explorer won’t start is when the engine turns when you engage the starter, but it won’t fire and run on its own.

What causes a car to crank but not start?

One of the biggest issues that causes a vehicle to crank but not start is ignition issues. When there is no spark, the engine will not start. You’ll probably have a misfire related code such as P0300, P0301, etc….. Ignition issues can be caused by many things, including bad spark plugs, bad coil packs, bad plug wires, computer issues, and more.

Why does my Ford 4.0L not turn over?

No Crank Condition The engine does not turn over when you turn the key to start your Ford vehicle. This is usually due to: Failed starter motor. Failed neutral safety switch. Failed ignition switch. Locked up engine.

Why does my car not start when I turn the key?

In other words, you turn the key and nothing happens since the engine won’t turn over. This usually due to a bad starter motor or a bad starter motor solenoid. Remember this article only deals with a no start condition.

What does it mean when your car says no start?

In a no crank condition, the engine is not cranking when you turn the key to crank the engine. In other words, you turn the key and nothing happens since the engine won’t turn over. This usually due to a bad starter motor or a bad starter motor solenoid. Remember this article only deals with a no start condition.

What should I do if my car won’t start?

There are tests you can do to verify all the different components of your starting system. Including your Neutral safety switch (NSS) or Clutch pedal position sensor if you have a manual transmission, your starter relay, the connectors going in and out of your starter including the A, B and S terminals and your Ignition Switch.

What does it mean when Your starter motor fails?

Starter motor failure produces one common symptom across all makes and models: When you turn the key, the starter solenoid will click, but the engine will not rotate. You also Read More

How to start a car with a bad ignition switch?

Jumper cables Open the hood of your car and locate the ignition coil and the battery. Then using a jumper cable, connect the positive terminal of the battery to the positive side of the coil. This will give power to the dashboard which is needed to start the engine.

What to do if your Ford Explorer is stolen?

Take off the top cover of the steering wheel or theres a little square cover you can pop open with a screw driver. Put the screw driver in the opening and push down on this piece that is spring loaded and pull down on your shifter. Put your car back in Park and start your car! Hope this helps you guys! 10 people found this helpful.

Why is my car engine not cranking over starter?

Engine is not cranking over – starter not working for me? Turn ignition to crank it will not start or turn over and no click sounds. Friend with me checked fuses seemed okay. Turned key to on crossed starter, engine turned over but would not start. He suggested either ignition switch bad or a neutral switch.

What does it mean when engine is not cranking over?

Not Cranking Over: Turn Ignition to Crank It Will Not Start or Turn ignition to crank it will not start or turn over and no click sounds. Friend with me checked fuses seemed okay. Turned key to on crossed starter, engine turned over but would not start. He suggested either ignition switch bad or a neutral switch.

How to diagnose no crank no start Ford?

No crank no start Ford issues are pretty easy to diagnose. Click on the illustration below and download the PDF wiring diagram of a typical Ford starting system.

Why does my 2004 Ford Explorer not start?