Why did my throttle cable break?
Why did my throttle cable break?
Sometimes a cable can become stretched over time, which will not only delay the response of the throttle, but can also leave the cable more susceptible to breaking. Delayed response may also be indicative of the need to have the cable slack adjusted.
How do you adjust the throttle cable on a motorcycle?
The accelerator cable tension is usually set so that 2-3mm of free play is present in the throttle grip. Once the correct tension has been applied, the lock nuts should be snugged and any dust covers should be slid back over the adjusters. Cables can be adjusted using the appropriate size wrench. Turn in to slacken, and out to tension.
Where are the adjustment points on the throttle cable?
Some applications have adjustment points at the throttle body or carburetor and at the throttle cable housing, while others have a single adjustment point on the throttle cable housing.
What should I do if my throttle cable is not returning?
If the throttle does not completely return the cable may be binding, incorrectly routed, frayed, or corroded, which warrants further investigation. With the bike OFF, twist the trottle open to the stop and let go.
How is the Free Play of the throttle cable checked?
Throttle cable free play is typically checked by measuring the amount of throttle grip movement relative to a fixed point on the throttle cable housing. Most makes/models specify 2-3mm of throttle grip free play.
How do you replace the throttle cable in a car?
Step 1: Push the new cable through the firewall. Push the new cable through the firewall and into the engine compartment. Step 2: Hook the new cable up to the accelerator pedal. Slide the new cable through the slotted hole in the accelerator pedal. Step 3: Reconnect the throttle cable to the retaining bracket.
Are there still drive by wire throttle cables?
Many modern vehicles use an electronically controlled throttle system, affectionately referred to as “drive-by-wire.” However, there are still vehicles on the road equipped with traditional, mechanical throttle cables, otherwise known as accelerator cables.
How is the throttle cable disconnected from the accelerator pedal?
Step 3: Pull the throttle cable through the firewall. Pull the new cable from the engine compartment into the interior. Step 4: Disconnecting the throttle cable from the accelerator pedal. Typically, the throttle cable is disconnected from the accelerator pedal by lifting up on the pedal and sliding the cable through the slotted hole.
