Easy lifehacks

Why are stub axles are fitted in front axles?

Why are stub axles are fitted in front axles?

These axles do not rotate with the driver when compared to live axles. The Dead front axle has sufficient rigidity and strength to transmit the weight of the vehicle form the springs to the front wheels. The ends of the axle beam shape suitably to assemble the stub axle.

What is purpose of stub axle?

A stub axle or stud axle is either one of two front axles in a rear wheel drive vehicle, or one of the two rear axles in a front wheel drive vehicle. In a rear wheel drive vehicle this axle is capable of angular movement about the kingpin for steering the vehicle.

How do you remove a drive axle from a car?

Place a steel punch in the edge of the brake rotor and rotate it until it contacts the brake caliper. Working against the punch, loosen the axle nut. There may be a cotter pin or staked edge keeping the nut in place.

Can a hub be removed from a rear wheel drive car?

Rear-wheel drive. On a rear-wheel-drive car you may not need to remove the hub carrier: if you can disconnect the drive shaft, you can dismantle the hub with the carrier still in place. The inner race of an inboard tapered roller bearing may remain on the drive shaft. If so, tap it off gently with a soft-faced hammer.

How do you replace wheel bearings on a front wheel drive car?

On a front-wheel-drive car, remove the entire hub-carrier assembly. Unscrew the nuts from the steering ball joints , and uncouple them with a ball-joint separator .

What to do if your CX axle shaft is stuck?

CX AXLE SHAFT STUCK – YouTube If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.

Is it easy to replace a front wheel drive axle?

If you make a right turn, it’s usually the left side that’s bad and vice versa. Most axles are easy to replace and the one depicted in this video is fairly typical of what you run into. The main differences come in with how the lower ball joint is attached. I think this part will give you the most trouble.

Can a slide hammer be used to remove CV axles?

Appears to be a good tool, but be advised it may not fit your car’s axle. I purchased this to help remove the CV axles in a 2007 Lexus ES 350. The opening of the joint puller attachment that threads on to the slide hammer shaft is not wide enough to go around the CV axle.

How do you remove the front axels from the differential?

How do you remove the front axels from the differential? I have already loosened the the four bolts holding the axel mounting braket on the right side of vehicle, and can see two rings inside a rubber one and a metel one with a snap ring. We also remove the two bolts holding the bracket to the frame.

Can a joint puller go around a CV axle?

The opening of the joint puller attachment that threads on to the slide hammer shaft is not wide enough to go around the CV axle. Therefore, this tool is essentially unusable for its intended purpose on this car. This dimension is not specified in the product listing, so one orders hoping that the tool fits.

Author Image
Ruth Doyle