Where is the TPMS reset button on Chevy Cobalt?
Where is the TPMS reset button on Chevy Cobalt?
Turn ignition to the ON/RUN position with the engine OFF (not the ACC position) and lower the driver’s side window. Press the Vehicle Information button (located to the left or right of the instrument cluster) repeatedly until “LEARN TIRE PRESSURES” is displayed. Then press the checkmark button.
How do you reset the TPMS light on a 2008 Chevy Cobalt?
Easy Way To Reset Chevrolet Cobalt TPMS Tire Pressure Sensor Light (2008-2010)
- Turn the ignition key to the “ON” position without starting the engine.
- Press the Remote Keyless Entry (RKE) transmitter’s LOCK and UNLOCK buttons simultaneously for five seconds.
- Activate the TPMS sensor.
What does SVC tire monitor mean on a 2008 Chevy Cobalt?
SVC tire monitor light came on. When the Service tire warning light is illuminated it typically indicates that there is a communication problem with the TPM sensors. However, it could also indicate a low tire pressure reading; especially when it’s extremely hot or cold.
How to reset TPMS tire pressure in Chevy Cobalt?
If you have 2008 2009 2010 Chevrolet Cobalt, you can reset the TPMS by increasing or decreasing the tire pressure without tools. Follow these instructions to get started: Turn the ignition key to the “ON” position without starting the engine. If your vehicle has an ignition button, press the Engine Start/Stop button without touching the brake pedal
When did Chevy Cobalt stop making road tires?
At the end of June 2010 production of the Cobalt was stopped. If you replacing a spare tire with a road tire containing the TPMS sensor on your Chevy Cobalt, the system will detect a malfunction and the low tire pressure warning light will blink.
What’s the best way to reset a low tire pressure light?
Probably the easiest method is to drive about 10 miles at 50 mph. Use the cruise control to keep the speed constant. Some vehicles reset the sensors at higher speeds than others. Shut off the car.
How do you reset the TPMs on a Chevy?
Starting with the LF tire, use a properly formatted TPMS scan tool to scan each sensor in the following order: LF, RF, RR and LR. The horn will chirp, after the vehicle has received a signal from each sensor. After activating the LR tire, the horn will chirp twice signifying the relearn is complete.
If you have 2008 2009 2010 Chevrolet Cobalt, you can reset the TPMS by increasing or decreasing the tire pressure without tools. Follow these instructions to get started: Turn the ignition key to the “ON” position without starting the engine. If your vehicle has an ignition button, press the Engine Start/Stop button without touching the brake pedal
At the end of June 2010 production of the Cobalt was stopped. If you replacing a spare tire with a road tire containing the TPMS sensor on your Chevy Cobalt, the system will detect a malfunction and the low tire pressure warning light will blink.
How to relearn tire positions on Chevy Cobalt?
• On vehicles not equipped with keyless entry, press and release the driver information center (DIC) INFO button until the RELEARN TIRE POSITIONS message appears on the DIC display. Press and hold the SET/RESET button until a double horn chirp sounds and the DIC displays a TIRE LEARNING ACTIVE message indicating the Learn Mode has been enabled.
What does low tire pressure signal mean on Chevy Cobalt?
A double horn chirp will sound and the low tire pressure indicator will begin to flash, indicating the learn mode has been enabled. • Hold the antenna of the J 46079 aimed upward against the tire sidewall close to the wheel rim at the valve stem location.
