Where is the timing gear on a fuel injection pump?
Where is the timing gear on a fuel injection pump?
The single dot on the idle gear should meet between the 2 dots on the timing gear. 8) Important: Be sure to check the pump oil after installation. Use 15W40 Rotella for both the engine and the pump. There are normally two small bolts on the back side of the pump that are used for fill levels.
How to remove injection pump gear from John Deere?
Remove injection pump drive gear cover. Shown removed (on John Deere Application) 6. Remove injection pump drive gear cover (shown removed). Remove drive gear retaining nut and washer from end of pump shaft. Be careful not to let washer fall inside timing gear cover.
How do you timing a Deere fuel pump?
The crank shaft must be timed at the flywheel. You then use a string to pull center of crank shaft to center of cam and have the cam mark inline with the string. You do the same thing with the fuel pump gear , center crank to center fuel pump shaft, except which mark used will be determined by type of injection pump.
How does a fuel injection pump work on a tractor?
5) Install the pump onto the fuel injection pump gear and bolt pump to the timing gear case. 6) This procedure should get your tractor running, but some fine-tuning may be required to achieve optimum performance. 7) Some timing gears have a set of two dots, which are the timing marks.
The single dot on the idle gear should meet between the 2 dots on the timing gear. 8) Important: Be sure to check the pump oil after installation. Use 15W40 Rotella for both the engine and the pump. There are normally two small bolts on the back side of the pump that are used for fill levels.
Remove injection pump drive gear cover. Shown removed (on John Deere Application) 6. Remove injection pump drive gear cover (shown removed). Remove drive gear retaining nut and washer from end of pump shaft. Be careful not to let washer fall inside timing gear cover.
The crank shaft must be timed at the flywheel. You then use a string to pull center of crank shaft to center of cam and have the cam mark inline with the string. You do the same thing with the fuel pump gear , center crank to center fuel pump shaft, except which mark used will be determined by type of injection pump.
5) Install the pump onto the fuel injection pump gear and bolt pump to the timing gear case. 6) This procedure should get your tractor running, but some fine-tuning may be required to achieve optimum performance. 7) Some timing gears have a set of two dots, which are the timing marks.
