Easy lifehacks

Where is the thermostat on a Dodge Stratus?

Where is the thermostat on a Dodge Stratus?

Loosen the petcock on the lower right hand side of the radiator and drain all of the radiator fluid into a drain pan. Close the petcock once drained. Trace the lower radiator hose to the location where the hose connects to the engine block. The metal housing the hose connects to is the lower thermostat outlet.

What are the symptoms of a bad thermostat?

The first and potentially most alarming symptom will be the temperature gauge reading high into the red within the first 15 minutes of your vehicle engine running. This is often the very first sign that the thermostat is not functioning properly.

What does the thermostat on a car do?

A car thermostat regulates the flow of coolant through the engine and is an incredibly important player in the operation of your vehicle’s engine. You may hear the phrase “the thermostat was stuck open or closed.” When the engine has been sitting for a while and is not warm, the thermostat will be closed.

Can a bad thermostat cause coolant to leak?

This can be noticeable in a variety of locations, but most commonly around the thermostat housing. This can eventually cause other coolant hoses to leak as well resulting in coolant often times leaking on the ground under your vehicle.

Loosen the petcock on the lower right hand side of the radiator and drain all of the radiator fluid into a drain pan. Close the petcock once drained. Trace the lower radiator hose to the location where the hose connects to the engine block. The metal housing the hose connects to is the lower thermostat outlet.

How do you cool a Dodge Stratus radiator?

Drive the Dodge onto a set of front-end ramps and secure the parking break. Allow adequate time for the radiator fluid to cool down. Thirty minutes is usually adequate. Loosen the petcock on the lower right hand side of the radiator and drain all of the radiator fluid into a drain pan. Close the petcock once drained.

How do you remove the radiator hose from a thermostat?

Remove the radiator hose from the thermostat intake housing by loosening the band clamp that secures it into place. With the clamp loosened, pull the hose off the housing. Remove the two bolts that secure the housing to the intake manifold and then lift the housing off the intake.

Drive the Dodge onto a set of front-end ramps and secure the parking break. Allow adequate time for the radiator fluid to cool down. Thirty minutes is usually adequate. Loosen the petcock on the lower right hand side of the radiator and drain all of the radiator fluid into a drain pan. Close the petcock once drained.

Remove the radiator hose from the thermostat intake housing by loosening the band clamp that secures it into place. With the clamp loosened, pull the hose off the housing. Remove the two bolts that secure the housing to the intake manifold and then lift the housing off the intake.

What happens when the thermostat on a Dodge Ram goes bad?

This article applies to the Dodge Ram (1994-2001). When your thermostat starts going bad, you are putting your engine at risk. Your thermostat sends a lot of information to the computer which takes that information to make decisions affecting the fan, water pump, and fuel and air mix among other things.

How do you change the thermostat on a Chrysler Sebring?

Slide the hose onto the Sebring’s thermostat intake housing. Tighten the clamp into place with the pliers. Open the radiator cap on the Chrysler’s radiator and pour the two gallons of fluid back into the radiator. “Chrysler Cirrus, Sebring, Dodge Avenger, Stratus, Plymouth Breeze Repair Manual 1995-1998”; Chilton Manuals; 1999

Where is the thermostat located on a Dodge Stratus?

The Thermostat is located inside the Thermostat Housing. If you follow the Radiator Hose up to the side of the Engine, it connects to the side of the Housing. You have to drain the Coolant, remove the Drive Belts, then remove the Hoses from the side of the Housing to get the Thermostat out.

Where is the thermostat located on a radiator?

Ok. The Thermostat is located inside the Thermostat Housing. If you follow the Radiator Hose up to the side of the Engine, it connects to the side of the Housing. You have to drain the Coolant, remove the Drive Belts, then remove the Hoses from the side of the Housing to get the Thermostat out.

How do you replace a lower thermostat on a Dodge Stratus?

The metal housing the hose connects to is the lower thermostat outlet. Remove the hose from the outlet by loosening the band clamp and then by pulling the hose off the outlet. Be careful–some fluid will drain from the hose.

Where is the radiator hose on a Dodge Stratus?

Find the location where the upper radiator hose connects to the intake manifold of the engine by tracing it from the radiator to thermostat intake housing bolted to the intake. Remove the radiator hose from the thermostat intake housing by loosening the band clamp that secures it into place.

Where is the thermostat on a Doge Stratus?

The Doge Stratus is equipped with either a four-cylinder engine or a six-cylinder engine. If you own a four-cylinder engine, the thermostat mounts in the traditional location on top of the intake manifold. If you own a six-cylinder engine, the thermostat mounts on the lower half of the engine block.

Author Image
Ruth Doyle