Where is the temperature sensor located on a 2008 Ford Focus?
Where is the temperature sensor located on a 2008 Ford Focus?
The sensor is located in the head between the 2nd and 3rd sparkplug. Finally, if you pull a trouble code P0128, this simply means that the computer is getting a lower than expected motor temp reading.
Where is the thermostat located on a Ford Focus?
Replacing the thermostat on the Focus is straightforward, as it is located at the engine end of the upper radiator hose. Lift the hood and prop it open. Follow the upper radiator hose to the thermostat housing. The thermostat housing is attached with three bolts. Unscrew the three bolts with a socket wrench. Pull the top of the housing off.
What should I do if my Honda focus is hot?
Place new gasket over the thermostat and replace housing cover. Reattach radiator hose, EGR tube and bracket and the coilpack wiring harness. Refill the radiator with reserve or new coolant. Start your Focus and allow the engine to warm up. Check for leaks. Do not attempt to drain coolant when the car engine is hot.
How do you replace the gasket on a Ford Focus?
Scrape off the remnants of the old gasket with a razor scraper. Insert the spring end of the thermostat in the housing. Lay the new gasket around the mating surface of the stationary part of the housing. Place the cover on top and secure it with the three bolts. Tighten the three bolts with a socket wrench.
How can I Keep my Ford Focus cool?
In less than an hour, you can be back behind the wheel of your Ford Focus. Make sure the engine of your Ford Focus is cool. Use jack and jack stands or wheel ramps to raise the front of your Focus. Turn radiator cap about 1/4-turn to release pressure in the cooling system.
What’s the torque on a Ford Focus thermostat?
The thermostat housing cover bolts have a torque wrench setting of 9 Nm / 7 lbf ft. Category Autos & Vehicles Show moreShow less Loading… AutoplayWhen autoplay is enabled, a suggested video will automatically play next. Up next
Place new gasket over the thermostat and replace housing cover. Reattach radiator hose, EGR tube and bracket and the coilpack wiring harness. Refill the radiator with reserve or new coolant. Start your Focus and allow the engine to warm up. Check for leaks. Do not attempt to drain coolant when the car engine is hot.
In less than an hour, you can be back behind the wheel of your Ford Focus. Make sure the engine of your Ford Focus is cool. Use jack and jack stands or wheel ramps to raise the front of your Focus. Turn radiator cap about 1/4-turn to release pressure in the cooling system.
Where is the radiator drain plug on a Ford Focus?
Locate radiator draincock on the passenger-side of the bottom of the radiator, facing the rear of the Focus. Attach a hose to the plug if desired to minimize coolant spillage. Loosen the plug to drain coolant into a suitable container. Reuse coolant if relatively new and clean.
