Where is the suction line located?

It is the section between the evaporator and compressor. At that stage the compressor is sucking vapor back thus suction line. For a tech it is where superheat is measured and refrigerant is charged.

Why is the suction line insulated?

Insulating the suction line is done to prevent condensate from developing and dripping off. This condensate drip can cause water damage to the material under it or cause a slip hazard for people walking below it.

Which is the suction side of the compressor?

The suction side of the compressor pulls in the refrigerant. Compressors only have two valves, and refrigerant flows in only one direction. If you can identify one of the valves, you have identified the other.

Where is the compressor bracket on a Chevy truck?

Compressor Adapter Bracket Set designed for use with the stock small block Chevy V8 compressor mounting bracket, located on passenger (right) side. Affordable alternative to replacing individual parts.

Which is the suction side of the crankshaft?

NOTE: CCI recommends that when positioning compressor at full 90ohorizontal, suction side should be on “top”. Cubic inch displacement can also be determined by crankshaft appearance as illustrated: 10 cubic inch sharp edge 9 cubic inch deep groove Compressor — Pressure Relief Valves (Also see Pressure Relief Section) 5683

What should the pressure be on my a / C compressor?

If you think that you have an issue with your A/C system but you are not sure which component is causing the malfunction it is a good idea to hook your compressor up to a pressure gauge. An A/C System that is working properly should have 150 PSI on the high side and 30 PSI on the low side.

Where is the low side service port on an AC compressor?

The low side service port is usually located between the AC compressor and evaporator. The low side service port will have a black or blue plastic cap that needs to be removed.