Where is the nut on the injection pump?
Where is the nut on the injection pump?
Remove the Drive Gear from the Injection Pump Loosen the 27 mm nut (This larger metric size socket can be replaced with an equivalent US size if necessary.) on the shaft on the front of the pump.
How to remove a Bosch fuel injection pump?
Remove the center larger nut and washer at the gear leaving the 3 smaller bolts tight. Now replace the larger nut without the washer leaving the nut flush with the end of the pump drive shaft, taking extreme measures not to drop anything into the timing gear cover. Loosen the mounting bolts on the pump side from the pump.
How do you remove the injection pump housing?
Remove the APPS or TPS Housing above the injection pump (three 13mm headed bolts). Leave all the cables attached and unplug the wire harness from underneath it by pushing on the locking tab of the plug while pushing on the plug until the lock releases. Then, still holding the lock tab in, pull on the plug to remove it from the housing.
How to remove Bosch pump on international tractor?
BOSCH VA PUMP INSTALLATION INSTRUCTIONS REMOVAL; INTERNATIONAL TRACTOR Clean the left side of the engine to prevent dirt entering the injection pump when the fuel lines and injection lines are removed. Shut off the fuel supply from the fuel tank.
Remove the Drive Gear from the Injection Pump Loosen the 27 mm nut (This larger metric size socket can be replaced with an equivalent US size if necessary.) on the shaft on the front of the pump.
Remove the APPS or TPS Housing above the injection pump (three 13mm headed bolts). Leave all the cables attached and unplug the wire harness from underneath it by pushing on the locking tab of the plug while pushing on the plug until the lock releases. Then, still holding the lock tab in, pull on the plug to remove it from the housing.
How do you replace timing nut on D & C diesel?
Once the pump is secured in the key way replace the center nut, replace the mounting bolts of the pump. Then place a socket on the center nut to rotate the pump shaft to re-align the timing marks in the side window as they were when you removed the pump.
How to remove Bosch VA pump from IH tractor?
A Downloadable PDF Version is available at a link on the bottom of this page To remove the Bosch VA Pump from IH tractors you will first need to remove the plate on the front of the timing gear cover directly in front of the injector pump.
