Where is the fuse box on a 2001 Chevy S-10?
Where is the fuse box on a 2001 Chevy S-10?
Chevrolet S-10 (2001) – fuse box diagram Year of production: 2001 Instrument panel The fuse block is in the instrument panel on the driver’s side.
How to troubleshoot a no start GM 4.3L pick up?
Testing a Cranks but Does Not Start condition on your GM 4.3L, 5.0L, 5.7L pick up, van or SUV is not that hard to do, if you have a solid diagnostic strategy. In this article I’ll show you the basics of testing such a problem.
How can you tell if there is a fuse in your car?
The wiring circuits in the vehicle are protected from short circuits by fuses. This greatly reduces the chance of damage caused by electrical problems. To check a fuse, look at the silver-colored band inside the fuse. If the band is broken or melted, replace the fuse.
Where is the fuse panel on a blazer?
Never replace a broken fuse with anything other than a new fuse. Use always an intact fuse of the same color. If a fuse blows again contact a qualified service center. The fuse panel is located under the dashboard. 1988-1994: Rear/Four Wheel Anti-Lock Brake Module, Digital Radio Adapter Module, Speedometer, Auto.
Chevrolet S-10 (2001) – fuse box diagram Year of production: 2001 Instrument panel The fuse block is in the instrument panel on the driver’s side.
What was cause of 1998 Chevy S10 no spark?
9 people found this helpful. Again my 1998 Chevy S10 No fire was caused by what is called an ignition igniter which sit on the side of my coil bracket next to the coil. I hope this will help someone with the same problem.
Do you need a spark plug for a Chevy S10?
NOTE When performing the following tests, the vehicle’s battery must be fully charged. WARNING Never crank the engine or turn the ignition switch on with a high-tension spark plug wire or ignition coil wire disconnected.
Why does my Chevy S10 Pickup not start?
It still will not start. The first time I tested ICM terminal D, it gave a reading of >10v. Since the replacement of the PCM, it shows <1v at terminal D. This is still a No Spark condition. Last summer I replaced the fuel pump & filter, the spider fuel injection assembly, and the heads.
What to do when Your Fuse goes out on your car?
To check a fuse, look at the silver-colored band inside the fuse. If the band is broken or melted, replace the fuse. Be sure to replace a bad fuse with a new one of the identical size and rating. Fuses of the same amperage can be temporarily borrowed from another fuse location if a fuse goes out.
When to replace a fuse on a blazer?
Replace the fuse as soon as possible. Before replacing a fuse check that the key has been removed from the ignition and that all the services are switched off and/or disengaged. Do not repair fuses and never replace a blown fuse with one that has a higher amp rating. This can cause damage to the electrical system and fire.
Can a broken fuse be replaced with a new fuse?
Do not repair fuses and never replace a blown fuse with one that has a higher amp rating. This can cause damage to the electrical system and fire. Never replace a broken fuse with anything other than a new fuse.
