Where is the EGR valve on a 2002 Ford Escape?
Where is the EGR valve on a 2002 Ford Escape?
The EGR valve sits on the top of the engine near the rear of the block and looks like a round disk with a small vacuum tube attached to the top center of the disk.
What does p0403 mean on a Ford Escape?
P0403 is a very common trouble code. It is a generic code, which means that it has the same meaning for the Ford Escape as it would any other vehicle. It affects the EGR (Exhaust Gas Recirculation System and technically means: P0403: EGR→ Circuit Malfunction
What are the symptoms of the p0403 trouble code?
What are the symptoms of the P0403 code? 1 The Check Engine Light will be illuminated and the code is set in ECM memory. 2 The engine may have pre-ignition on acceleration. 3 The engine EGR system will be disabled by the ECM.
How much does it cost to diagnose Ford code p0403?
The cost to diagnose the P0403 FORD code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour. How much do you know about cars? When is the code detected?
What does the p0443 Ford engine code mean?
P0443 FORD Meaning. The Evaporative Emission System (EVAP) canister purge volume control solenoid valve uses a ON/OFF duty to control the flow rate of fuel vapor from the EVAP canister.
P0403 is a very common trouble code. It is a generic code, which means that it has the same meaning for the Ford Escape as it would any other vehicle. It affects the EGR (Exhaust Gas Recirculation System and technically means: P0403: EGR→ Circuit Malfunction
Can a service engine light misfire on a Ford Escape?
Most of the time, there will be no noticeable symptoms accompanied with P0403, with the exception of the service engine soon light itself. While not typical for any other symptoms to show with the P0403, it is possible that the Escape will misfire if the EGR system is stuck open.
What does circuit malfunction mean on Ford Escape?
It is a generic code, which means that it has the same meaning for the Ford Escape as it would any other vehicle. It affects the EGR (Exhaust Gas Recirculation System and technically means: A circuit malfunction implies that there is a wiring problem coming to or from the EGR system. That does not rule out the EGR solenoid itself.
What causes an OBD code of p0403?
The causes for a P0403 EGR code could be any of the following: Bad EGR solenoid Excessive resistance in control circuit (PCM controlled ground) due to an open, chafing or damage to the harness Poor connection at the EGR solenoid harness (worn or loose pins) Water intrusion at the EGR solenoid harness
