Where is the blower motor resistor on a 97 Ford F150?
Where is the blower motor resistor on a 97 Ford F150?
The blower motor resistor is located under the hood, mounted to the firewall on the passenger’s side.
Are there any problems with my 1997 Ford F-150?
See all problems of the 1997 Ford F-150 . When pressing the brake pedal the pedal gets hard and goes to the floor. Took to the dealer and the left sensor on the rotor was bad. Three months later, both sensors were bad.
What was the ABS code on my 2002 Ford F-150?
Abs system malfunctioned code reported by service tech was c-10-95 and stated that I would need to replace the hydraulic control unit. Failure occurred at only 17,500 mile on the unit. See all problems of the 2002 Ford F-150 .
Where is the ignition relay on a 1997 Ford F150?
It is the small relay second from the top left corner. I checked for ignition power on the lower right terminal, 12 volts, good. I checked for ground at the upper right hand terminal by first placing one lead of my voltmeter to a positive battery source, 0 volts, bad.
What are the problems with a 2001 Ford F-150?
1. Loss of brake fluid, tough to brake, brake light went on 2. Abs module corroded 3. Abs module replaced at my expense ($1400. 00). See all problems of the 2001 Ford F-150 .
When to replace Powertrain Control Module in Ford F-150?
Due to the complexity and cost of this item, only replace the module after doing some research and eliminating other possible causes. Your research should include checking for any Service Bulletins that may have been issued for your vehicle.
What is the PCM in a Ford F-150?
The PCM is the brain of your F-150. It is the central computer that controls everything, which includes the charging system, transmission, various emission controls, and communications.
Where is the ABS pump on a Ford F150?
Unscrew the 4 screws that hold the module on the ABS pump/housing with a torx bit. Please note that your ABS pump is directly under the ABS module and there is a harness that connects to it. You will also need to remove the harness on the rear of the module.
Where are the DTCs located on a Ford F-150?
The DTCs are read through the interface connector that is located under the dashboard. Figure 1. PCM Location. In addition to scanning the codes, gather some information about your PCM before taking anything apart. The code is located on the module as shown in Figure 1 above.
