Where is the anti-theft code on a Chrysler 300?
Where is the anti-theft code on a Chrysler 300?
The key must be in the “RUN” position. Press the “ON/VOL” control button. The word “CODE” or ” Please enter Anti-Theft Code” will appear on the display.
When did Chrysler start the anti theft system?
Chrysler anti-theft systems have gone through a few iterations. Starting in 1989, Chrysler started installing them on the C, G, and J body styles. The engine controllers in that era were referred to as SMEC (single module engine controller).
How to change Sentry Key theft deterrent system?
When a Powertrain Control Module (PCM) is replaced on vehicles equipped with the Sentry Key Theft Deterrent System (SKIM), it must be initialized to properly function with the anti-theft module. This is accomplished at a Chrysler Group Dealer by using the DRBIII or StarSCAN Scan Tool to enter a PIN number.
How do I clear the anti theft code?
As Cool_V_300C noted, as long as your original radio is the one installed, the Anti-Theft code will clear itself in time. Turn the car off, making sure that you give it enough time to really turn off by opening a door and waiting for the blue light around the USB port in the center console to turn off, then turn it back on.
When do I need an anti theft code for my Radio?
All radios now require an anti-theft code no matter what year vehicle they are installed in. The anti-theft code is only needed when a radio is swapped from one vehicle to another. The radio keeps track of the VIN over the bus and when the VIN changes it will ask for the code.
Chrysler anti-theft systems have gone through a few iterations. Starting in 1989, Chrysler started installing them on the C, G, and J body styles. The engine controllers in that era were referred to as SMEC (single module engine controller).
What happens if you enter an invalid anti theft code?
NOTE: If three consecutive attempts are made to enter an invalid anti-theft code the radio will enter a ‘WAIT’ state. While in this state the radio display will read ‘WAIT’. To exit the ‘WAIT’ state the radio must remain powered with the ignition in the run position for a continuous 30 minutes (the vehicle may be driven during this time).
How do you enter an anti theft code?
Enter the 4-digit code by pressing the corresponding preset buttons in sequence. NOTE: If three consecutive attempts are made to enter an invalid anti-theft code the radio will enter a ‘WAIT’ state. While in this state the radio display will read ‘WAIT’.
How to get anti theft code after battery disconnect?
For the vehicles that are equiped with power net or NTG4 radios. If the Telematics Gateway Module (TGW) or the radio have been removed or replaced. A four digit security code is required in order for the radio to function: The key must be in the “RUN” position. Press the “ON/VOL” control button.
