Where are the exhaust bolts on an AVA Voyager?
Where are the exhaust bolts on an AVA Voyager?
1. Put bike on center stand. 2. Disconnect wiring connectors then remove saddlebags. 3. Remove two bolts for the exhaust for each side. Bolts are under the rear floorboards and aft. 4. Loosen the bolts to the exhaust just forward of the crossover tube for the mufflers. One on each side. 5.
What to do with a new AVA Voyager filter?
Apply silicon or other sealant in the bottom of the basket and place the wire side of the new filter down into the sealant. Don’t forget to the reinstall white plastic ladder looking holders. The cost at our local Advanced Auto Parts was under $5.
What should the tire pressure be on a Voyager?
B. Heavier loads-dual riding and/or luggage (from 200 lb. total up to maximum motorcycle capacity stated in the owner’s manual)-pressure of 36 psi front and 40 psi rear must be maintained. Please Note: For any dual riding or fully loaded use, 40 psi must be maintained in all Dunlop rear tires fitted to touring motorcycles.
What kind of lubricant do you use on Kawasaki Ava Voyager?
Do not use gasoline, motor oil, or any other petroleum distillate, as this will cause deterioration of the rubber parts. When lubricating these shafts, Kawasaki recommends using a Poly Butyl Cuprysil grease (PBC is a special high temperature, water resistant grease).
1. Put bike on center stand. 2. Disconnect wiring connectors then remove saddlebags. 3. Remove two bolts for the exhaust for each side. Bolts are under the rear floorboards and aft. 4. Loosen the bolts to the exhaust just forward of the crossover tube for the mufflers. One on each side. 5.
Apply silicon or other sealant in the bottom of the basket and place the wire side of the new filter down into the sealant. Don’t forget to the reinstall white plastic ladder looking holders. The cost at our local Advanced Auto Parts was under $5.
B. Heavier loads-dual riding and/or luggage (from 200 lb. total up to maximum motorcycle capacity stated in the owner’s manual)-pressure of 36 psi front and 40 psi rear must be maintained. Please Note: For any dual riding or fully loaded use, 40 psi must be maintained in all Dunlop rear tires fitted to touring motorcycles.
Why does my Ava Voyager make a squeal sound?
It may or may not emit a squeal, which more likely may be a out-of-service limit brake pad, but if your brake pads are within service limits and you still hear a squeal or one of the before mentioned symptoms, or you feel your pads are prematurely wearing out, then read on.
What kind of air filter do I need for my Voyager?
A STP SA3915 replacement air filter will fit perfectly into the Voyager OEM white plastic basket by trimming approximately 1/8″ off two opposite ends with a razor cutter. Apply silicon or other sealant in the bottom of the basket and place the wire side of the new filter down into the sealant.
Where can I find Ava Voyager XII Tech Tips?
The newest 1200 Tech Tips may first be displayed in the AVA Members Group in the AVA Forum. Click Here to go to Page 1 of the Voyager XII Tech Tips. The Tech Center does not contain all available tech tips for the Voyagers, the most recent are contained in the hardcopy newsletters, with still others contained in the Tech Tips Manual.
